-
35, 33 Rear part of the adapter Figure 5-8 Clean the motor and adapter with fresh water after getting them detached. c. Detaching from universal adapter Step1: Loosen the ratchet strap buckles (Figure 5-9). First, unfold the strap buckle by 180° by pressing the limiting stopper. Second, pull the longer side of the strap 180° Press the limiting stopper Figure 5-9
…
-
37, ePropulsion LAGOON 35 Rear part of the adapter Figure 5-12 If you are not going to use the universal adapter very soon, it’s advised to detach the ratchet straps from the adapter. Clean the motor and adapter with fresh water after getting them detached.
…
-
44, Thanks for reading this user manual. If you have any concerns or find any problems while reading, please don't hesitate to contact us. We are delighted to offer service for you. ePropulsion Innovation (HK) Ltd. Website: www.epropulsion.com Email: [email protected]
…
-
6, ePropulsion LAGOON 4 5. Detaching LAGOON Motor ................................................................ 30 6. Transport and Storage .......................................................................36 6.1 Transport .......................................................................................36 6.2 Storage ..........................................................................................36 7. Routine Maintena…
-
7, 5 1. Important Safety Instructions This user manual contains important information pertaining equipment installation and safety instructions. Before starting to use the product, please read this manual fully and pay special attention to the following safety instructions: Before Operation Users who are allowed to use LAGOON should be in good physical state, know how to swim and how to paddle. Always wear a life vest and always wear a leash when operating. Always take a paddle on board. Only adults who have thoroughly read and fully underst…
-
11, 9 2.2 Parts and Diagrams LAGOON Controller LAGOON Motor Power Cable LAGOON Battery Figure 2-1 LAGOON Overvies Propeller Motor Module Power Cable Motor Base Protective Frame Side ViewFront View Figure 2-2 LAGOON Motor Power Button LED Lights Charge/Discharge Port Battery Buckles Bottom ViewFront View Figure 2-3 LAGOON Battery
…
-
40, ePropulsion LAGOON 38 8. Warranty The ePropulsion limited warranty is provided for the rst end purchaser of an ePropulsion product. Consumers are entitled to a free repair or replacement of defective parts or parts which do not conform with the sales contract. This warranty operates in addition to your statutory rights under your local consumer law. 8.1 Warranty Policies ePropulsion Innovation (HK) Ltd. keeps its products free of defects in material and workmanship for a limited period …
-
42, 40 3. The defective components or parts will be either repaired or replaced according to the diagnosis made by the ePropulsion authorized service partner. 4. If your warranty claim is accepted, the equipment will be repaired or replaced free of charge. 5. After careful examination and confirmation by ePropulsion authorized dealer, the defective or faulty components will be repaired or replaced based on actual condition. 6. In case your warranty claim be rejected (please refer to out of warranty …
-
15, 13 CE Test Report No.: ATT1710200303E, ATT1710200303M,ATT1710200303D Issued Date: October 20, 2017 This device complies with part 15 of the FCC Rules: Operation is subject to the following two conditions: (1) This device may not cause harmful interference and, (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Test Report No.: GTS201611000175E01 Issued Date: December 09, 2016 FCC Statement This equipment has been tested and found to co…
-
31, ePropulsion LAGOON 29 4.3 Pairing Remote Control to Battery LAGOON Remote Control has been paired to LAGOON Battery prior to delivery, but pairing job has to be carried out if the original LAGOON Battery or LAGOON Remote Control is replaced with a new one. Users can follow the following instructions to nish pairing. 1) Turn off the remote control and hold it within 10cm of the battery LEDs. 2) Power on LAGOON Battery (press its power button for 2s). Four LEDs start to blink alternatively in …
-
4, 2 Product Identication Below Figure 0-1 indicates the position of the serial number for LAGOON Battery. Figure 0-2 and Figure 0-3 indicate the position of serial numbers for LAGOON Remote Control and LAGOON Motor. CAUTIONS FCC ID: 2AKHE-LAGOON READ USER MANUAL FIRST DO NOT DISASSEMBLE Model: 24V Li-ion Battery Rated Capacity: 333Wh Rated Voltage: 22.2 V Charging Temperature: 0°C~45°C(32°F~113°F) Discharging Temperature: -20°C~60°C(-4°F~140°F) KEEP AWAY FROM FIRE/HEAT SOURCE DL AB1FC0001 S/N: DLAB1FC0001 FCC ID: 2AKHE-LAGOON S/N: X…
-
27, ePropulsion LAGOON 25 switched on, the battery will enter sleep mode automatically, then the four LEDs will all go off. The battery should be restarted if it is going to be used again. 4.1.3 Charging the Battery Important notes before charging Only use LAGOON Charger to charge LAGOON Battery. Do not use any third party chargers. Only charge the LAGOON Battery in within 0˚C~45˚C (32˚F~113 ˚F). Avoid water contact during charging process. Avoid direct sun/rain exposure during charging …
-
36, 34 Step2: Detach the LAGOON universal adapter and LAGOON Motor from the SUP/kayak, etc. Figure 5-10 Hold the LAGOON Motor while loosening the ratchet strap. Step3: Pull the release buckle and slide the universal adapter in the direction of the arrow. Fig ure 5-11 Step4: When the rear part of the universal adapter is slid to the position as shown in below left gure, take out the adapter. Release buckle
…
-
18, ePropulsion LAGOON 16 2) Turn the SUP/kayak bottom up to attach the inatable SUP n box. Step1: Slide the standard adapter into the cave of the inatable SUP n box. Step2: Insert the retaining clip into the place indicated in Figure 3-4 to x the adapter. 1 retaining clip 2 Figure 3-4 Do not force the adapter into the n box. If the adapter can’t t into the n box properly, slide it out and check if the installing direction is correct. The propeller should face the tail of th…
-
13, 11 2.3 Technical Data LAGOON General Data Input power 300W Static thrust 23lbs Total weight 4Kg / 8.8lbs LAGOON Motor weight 1.5Kg / 3.3lbs Dimension 162mmx167mmx182 mm / 6.4”x6.6”x7.2” Propeller diameter 150mm / 5.9” Propeller pitch 115mm / 4.5” Max propeller speed in rpm 1800rpm Control method Wireless LAGOON Battery Battery type Lithium-ion Rated capacity 324Wh Rated voltage 21.6V Final charging voltage 25.2V Cutoff voltage 18V Weight 2.5Kg Cycle li…
-
20, 18 Figure 3-7 The propeller should face the tail of the SUP/kayak, etc. While installing the universal adapter, make sure the adapter is in alignment with the bottom centerline of the SUP/kayak, etc. 3.2 Fixing LAGOON Battery a. Fixing LAGOON Battery on SUPs There are two major methods of xing the LAGOON Battery on an SUP. For SUP with a bungee system, the battery can be xed with the bungee cords. SUP bungee cord Velcro tape Figure 3-8 Fix the battery with the SUP bungee cords
…
-
41, 39 number, Warranty Card, and evidence of purchase from an authorized ePropulsion dealer. Valid date of purchase should be established by the rst-hand purchaser with original sales slip. Free warranty is not transferable and will not be reissued. 8.2 Out of Warranty Make sure the product is properly packed during delivery, the original product package is recommended. If the product got further damaged due to improper packing during…
-
12, ePropulsion LAGOON 10 Throttle On/Off Button Velcro Tape Figure 2-4 LAGOON Remote Control Inflatable SUP fin box adapter US fin box adapter LAGOON universal adapter Ratchet Strap Strap Buckle Screw Back Nut Retaining Clip Figure 2-5 Adapters
…
-
5, 3 Acknowledgements ............................................................................... 1 Using this Manual...................................................................................1 Symbols ..................................................................................................1 Product Identication ............................................................................2 Table of Contents ..................................…
-
34, 32 Figure 5-5 Step2: Slide LAGOON Motor and adapter out of the n box. Figure 5-6 Step3: Pull the release buckle and slide the adapter backward in the direction of the arrow. Figure 5-7 Step4: When the rear part of the adapter is slid to the postion as shown in below left gure, take out the adapter. Release buckle
…
-
30, 28 4.2.3 Replacing Battery for Remote Control LAGOON Remote Control is powered by a built-in battery (model: CR2032). If the remote beeps continuously when the remote control is switched on and powers off in 10 seconds, it indicates that the button cell is of low battery level and replacement of a new cell is required. You can replace a new button cell by below steps: Step1: Screw the battery cover counterclockwise (from ① to ② ) to unlock. Step2: Replace a new b…
-
19, 17 1 2 Figure 3-5 3) Fix the two ratchet straps: rst, penetrate the strap into the buckle; then, repeat unfolding and folding the buckle to tense the strap. Fold the buckle when the strap is tensed. 1 2 Figure 3-6 4) Attach the motor module to the universal adapter in the arrow direction.
…
-
3, 1 Acknowledgements Thanks for choosing ePropulsion products, your trust and support in our company are sincerely appreciated. We are dedicated to providing high- performance underwater thrusters, as well as electric outboards, reliable lithium batteries and accessories. Welcome to visit www.epropulsion.com and contact us if you have any concerns. Using this Manual Before use of the product, please read this reference manual thoroughly to understand the…
