-
25, 25 WARNING Do not operate the i-mop XL Plus at greater than arm’s length. Operating below a 45- degree angle can cause water to run into the vacuum engine. Figure 18 6.2.3 ECO mode The ECO mode will use 40% less cleaning solution. 1. Turn on the ECO mode by pushing the ECO button ( Figure 19, pos 1). 2. Turn off ECO mode by pushing the ECO mode again. …
-
17, 17 5 Assembly and installation The i-mop® XL Plus does not require much assembly. Most importantly, you will have to attach the brushes and squeegee. 5.1 Unboxing The i-mop XL Plus body is packed in a single box. The battery and charger are delivered in a separate box and can be ordered separately. Figure 8 Legend 1. 1x i-mop XL Plus main body 6. 1x squeegee assembly 2. 2x batteries (whe…
-
33, 33 8 Troubleshooting Problem Cause Solution No power No batteries Insert batteries Empty batteries Charge batteries Batteries incorrectly placed Remove and reinstall batteries Insufficient/no water flow Wrong program Check the operating mode on the control panel Eco mode on Check the ECO mode light on the control panel Empty tank Fill the tank Tank incorrectly placed The tank valve must be clicked on the nipple to open the seal, replace the tan…
-
5, 5 Content Preface .................................................................................................................................................................... 3 Purpose of the user manual .................................................................................................................................... 3 Target audience ..................................................................................................…
-
21, 21 6 Operation 6.1 Before you start Check the brushes and squeegee for wear and tear (refer to section 7 on maintenance). 6.1.1 Insert the batteries Figure 13 1. Push the blue coded battery (Figure 13, pos 2) in the blue battery slot. A click signals the battery is locked in place (Figure 13, pos 1). 2. Push the gray coded battery in the gray battery slot. A click signals the battery is locked in place. 3. During operati…
-
20, 20 5.2.5 Install cleaning solution tank 1. Put the tank (Figure 12, pos 1) on the i-mop® XL Plus with the valve first. 2. Press the tank downward on the nipple to break the valve seal. 3. Push the tank into place until you hear a "click". Figure 12
…
-
10, 10 1.6 Warranty The i-mop® XL Plus should be used as intended and described in this manual. Using the i-mop XL Plus outside will void the warranty on the product. 1.7 Identification The ID tag, containing a serial number and production number, can be found on the bar behind the wastewater tank. 1. Serial number 2. Production day 3. Production year Figure 3
…
-
3, 3 Preface Thank you for choosing the i-mop® XL Plus, the industrial auto scrubber that cleans faster, cleaner, safer, greener, and is better for everyone. The i-mop XL Plus' compact design allows you to clean right to the edge and under obstacles, minimizing manual scrubbing. The battery operated i-mop XL Plus is equipped with two counter-rotating brushes that provide a deep scrub and a great cleaning result. The i-mop XL Plus signi…
-
32, 32 7.5 Recommended service time When you do not have a Service Agreement, check the timer on the control panel on a regular basis. It is recommended to schedule a full service by one of our service partners every 500 hours. Each click on the timer on the control panel registers 6 minutes of operation. The i-mop® XL Plus requires service every 5000 clicks. 7.6 Accessories The i-mop XL Plus can be equipped with different brushes and …
-
22, i-team i-mop XL Plus 22 6.2 Operation procedure 6.2.1 Walking to the job site Figure 15 To move the i-mop® XL Plus from one location to another one in a building: 1. Put the i-mop XL Plus in park position (refer to section 4.2). 2. Hold the handle with one hand (Figure 15, pos 1). 3. Walk slowly and pay extra attention if you pull the i-mop XL Plus over obstacles. 4. To lift the i-mop XL Plus over obstacles, always use two hands. • Hold the…
-
29, 29 7 Maintenance 7.1 Brush replacement Figure 25 The brushes are attached to the scrub deck via a bayonet fitting. 1. Put the i-mop® XL Plus in park position (refer to section 4.2). 2. Hold the scrub deck firmly with one hand. 3. Using your other hand to turn the left brush (Figure 25, pos 1) anticlockwise until you feel resistance or see the motor disk turning as well. 4. Pull the brush off the m…
-
12, 12 3 Safety Safety comes first. Therefore, please take your time to read and understand these safety instructions. Improper use can cause harm or void the manufacturer’s warranty. 3.1 General safety instructions 3.1.1 Sweep before scrub Remove objects from the floor that can be propelled by the rotating brushes. 3.1.2 Brush condition Make sure to check the condition of the brush before use. Change the brush only when the machine is turned off in a park position. 3.1.…
-
8, 8 1.2 Non-intended use of the product WARNING Non-intended use can have consequences for the safety of operators and bystanders and will void the warranty on the product. • NEVER operate the i-mop® XL Plus near flammable dusts, liquids or vapors. • NEVER operate the i-mop XL Plus when flammable or poisonous liquids like gasoline, oil, acids, or other volatile substances are on the floor. • DO NOT fill the i-mop XL Plus with any flammable…
-
6, 6 5.2.2 Attach the brushes .......................................................................................................................... 18 5.2.3 Attach the squeegee ....................................................................................................................... 19 5.2.4 Install recovery tank ........................................................................................................................ 19 5.2.5 Install clea…
-
11, i-team i-mop XL Plus 11 2 Description The compact i-mop® XL Plus consists of two main parts: • The body that contains the motor, cleaning solution tank, recovery tanks, handle with triggers and control panel. • The scrub deck that contains the brushes and squeegee. The i-mop XL Plus can be folded into a park position; this is recommended for storage. The i-mop XL Plus consists of: Figure 4 Legend 1. Trigger 6. Vacuum hose 2. Control panel 7. Rotating brushes …
-
1, i-mop XL Plus Auto scrubber for hard floor surfaces User manual i-team Professional b.v. Hoppenkuil 27b, 5626 DD Eindhoven, The Netherlands Telephone: +31402662400 Email: hello@i-teamglobal.com Internet: www.i-teamglobal.com
…
-
18, i-team i-mop XL Plus 18 5.2 Assembly 5.2.1 Charge the batteries Charge the batteries according to the instructions in the battery charger manual. Make sure the battery packs are charged monthly. 5.2.2 Attach the brushes To attach the brushes: 1. Put the i-mop® XL Plus in park position (refer to section 4.2). 2. Hold the scrub deck firmly with one hand. 3. Align the left brush (Figure 9, pos 1) with the left motor disk (Figure 9, pos 2). Align t…
