Tannoy CMS60 TDC – 60 Operation & User’s Manual

Operation & User’s Manual for Tannoy CMS60 TDC – 60 Monitor (18 pages)

Specifications:

219/219003-cms60_tdc__60.pdf file (26 Dec 2023)
  • Manufacturer: Tannoy
  • Category of Device: Monitor
  • Document: CMS60 TDC – 60, File Type: PDF Operation & User’s Manual
  • Updated: 26-12-2023
  • Count of Pages: 18
Download CMS60 TDC – 60 Manual (18 pages)

Read Tannoy CMS60 TDC – 60 Document Online:

Data: UPD 26th December 2023

Tannoy CMS60 TDC – 60 Monitor PDF Operation & User’s Manual (Updated: Tuesday 26th of December 2023 12:37:15 PM)

Rating: 4.5 (rated by 29 users)

Compatible devices: REVEAL TS12 s, SYSTEM 600a, System 800, Reveal X, Precision 6, System 600, SYSTEM 15 DMT II, REVEAL 66.

Recommended Documentation:

Text Version of Tannoy CMS60 TDC – 60 Operation & User’s Manual (Summary of Contents)

(Ocr-Read of the Tannoy CMS60 TDC – 60 Document (Main Content), UPD: 26 December 2023)
  • 1, B CMS60 TDC – 60 / CMS60 TDC - 8 User Manual HOLE CUT- OUT SIZE 305mm (12”) …

  • 3, Tannoy CMS60 TDC – 60 CONTENTS 1. Introduction 2. Unpacking 2.1 CMS60 TDC – 60 / CMS60 TDC - 8 – The Product 2.2 The C-ring 2.3 The Tile Bridge and C-ring 2.4 The Plaster ‘Mud’ Ring 3. Installation Instructions 3.1 Hole Cut Out 3.2 Connections 3.3 Installation 3.4 Speak…

  • 4, Tannoy CMS60 TDC – 60 1. Introduction The Tannoy CMS60 TDC – 60 / CMS60 TDC - 8 Ceiling Monitor System has been designed for high-level music and speech reinforcement applications requiring exceptional sonic quality with uncompromised reliability. The utmost consideration has been given to the installation procedure to …

  • 5, Tannoy CMS60 TDC – 60 2.1 CMS60 TDC – 60 / CMS60 TDC - 8 – The Product 2.2 The C-ring (Optional) 2.3 The Tile Bridge and C-ring (Optional) 2.4 The Plaster ‘Mud’ Ring (Optional) …

  • 6, Tannoy CMS60 TDC – 60 3. Installation Instructions 3.1 Hole Cut Out The cutout size required is 305mm (12”) 3.2 Connections The CMS60 TDC – 60 / CMS60 TDC - 8 is provided with a plugable European type connector, which is located on the back of the speaker can, under the wiring cover as shown in Figure 3…

  • 7, When the plug has been connected, close the wiring cover as shown in Figure 3d, below: Place the wires in the recess in the cable clamp. Close the cable clamp as shown in Figure 3e and tighten the screw holding the clamp in order to secure the cables in place. Figure 3d Figure 3e …

  • 8, Tannoy CMS60 TDC – 60 Slide the speaker through the 305mm hole, as shown in figure g, and tighten the outer screws on the front baffle. Tighten these screws until a secure grip is established as shown in Figure h. Figure g Figure h …

  • 9, Tannoy CMS60 TDC – 60 3.4 Speaker Assembly with C-ring To spread the weight / pressure of the 4 tags, an optional C-ring is available for the CMS60 TDC – 60 / CMS60 TDC - 8. To install the speaker in the ceiling, place the C-ring behind the surface by separating opening of the C-ring and twisting it through the hole. Sli…

  • 10, 3.6 Speaker Assembly with Plaster ‘Mud’ Ring An optional plaster (Mud) ring can be used if a conventional ceiling tile is not being used. The wings on the plaster ring are attached to the building structure using the holes provided. The plaster is then applied over the bracket. …

  • 11, 5. Amplification and Power Selection (Low Impedance Mode) As with all professional loudspeaker systems, the power handling is a function of voice coil thermal capacity. Care should be taken to avoid running the amplifier into clip (clipping is the end result of overdriving any amplifier). Damage to the l…

  • 12, 7. Equalisation The CMS60 TDC – 60 / CMS60 TDC - 8 is designed to need no equalisation or correction to overcome system limitations. As a result, it will only need equalisation to compensate for difficult acoustic environments. Excess equalisation can reduce system headroom, and introduce phase d…

  • 13, Tannoy CMS60 TDC – 60 9. Performance Data Unprocessed Anechoic Frequency Response, 1 watt @ 1 metre Impedance Beamwidth vs Frequency 0 30 60 90 120 150 18…

  • 14, 10. Technical Specifications Frequency Response (1) +/-3 dB 50Hz - 20kHz Sensitivity 1W @ 1m (3) 90dB (anechoic) 93dB (half space) Maximum SPL THP 60 108dB(average) 114dB(peak) Low Impedance109dB(average) 115dB(peak) Power Handling (2) Average 80 watt Programme…

  • 15, 11. CMS60 TDC Recommended Service Parts & Accessories Part Number Description 7900 0437 Driver Kit – 6.5” Type 1667 7900 0306 Recone Kit 7900 0648 HF Diaphragm 8001 1920 CMS60 C Ring 8000 1910 CMS60 Tile Bridge 8000 1900 CMS60 Plaster Ring 12. Warranty No maintenan…

  • 16, The following apparatus is/are manufactured in the United Kingdom by Tannoy Ltd of Rosehall Industrial estate, Coatbridge, Scotland, ML5 4TF and conform(s) to the protection requirements of…

  • 18, Tannoy Loudspeakers are manufactured in Great Britain by : Tannoy Ltd, Rosehall Industrial Estate, Coatbridge, Strathclyde, ML5 4TF, SCOTLAND Telephone: +44 (0)1236 420199 Fax: +44 (0)1236 428230 Tannoy North America Inc, Sui…

DOC-3a824e88:

Recommended:
FNC-0107TX, Crossroads, TV 641 GH, VR368

Additional Information:
# Brand Model Document Type/File Pages File Size Last Checked
1 Efitment
RB034
14 15/09
2 Samsung
HPS5033 - 50" Plasma TV
147 24/09
3 Logic
ZOOM
10 13/01
4 HP
C200
66 21/12
5 ViewSonic
VA2616w
25 0.54 Mb 04/09
6 LG
M2362DP-PC
156 12/12
7 Eizo
FLEXSCAN SX2262W -
2 6.07 Mb 11/08
8 Samsung
400TXN
189 02/11

Popular Right Now:

# Brand Model Document (PDF) Pages Size Check Date
1 Swann
SR11020
12 13.12.2023
2 Vxl
Itona TC1410
2 0.83 Mb 18.01.2024
3 Panasonic
DMPBD871
40 1.68 Mb 08.09.2023
4 Panasonic
NN-SN657S
30 0.58 Mb 01.12.2023
5 Sym
Quad Lander 250
223 27.09.2023
6 GRASS VALLEY
8920ADT
1 0.25 Mb 19.01.2024
7 Sanyo
SAP 241RC
4 0.23 Mb 26.11.2023
Operating Impressions, Questions and Answers: