-
18, ___________________________________________________________________________________________ 18 www.hightechpet.com High Tech Pet Products, Inc. REPLACING THE MS-4 BATTERY 1, Insert screwdriver or knife in end slot and pry open. 2. Separate top from bottom. 3. Replace battery top with the metal ring visible. 4. Carefully mate top and bottom while keeping aluminum speaker centered in the top hole. Squeeze together the top and bottom until both ends snap.
…
-
11, High Tech Pet Power Pet ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 11 Battery Installation To install the battery, open the battery compartment, and align the two battery lugs with the two lug sockets on the inner wall of the battery compartment. Then press the battery to mate it to the sockets. When done the battery should be ush with the wall, and the compartment cover shou…
-
10, ___________________________________________________________________________________________ 10 www.hightechpet.com High Tech Pet Products, Inc. Now, set your desired range and access per your user manual. You and your pet are now ready to enjoy the freedom and beauty of your POWER PET sliding glass door. If you still have questions, give us a call at 800-255-1279 and, together, we’ll make sure your pets can enjoy the life they deserve. Initial Power up Plug the AC Adaptor into a nearby 110 VAC wall outlet. Plug adap…
-
7, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 7 High Tech Pet does not stop at weather stripping. Our sliding glass doors must meet our rigid standards of weather resistance, so we go a step further and supply a draft stopper! 5. Apply the draft stopper to the back of your sliding glass door. (Figure 4) 6. Peel the clear protective …
-
8, High Tech Pet Power Pet ___________________________________________________________________________________________ 8 www.hightechpet.com High Tech Pet Products, Inc. 3. Drill the hole rst using a 1/8 inch drill bit and then nishing with a 1/4 inch drill bit. (Figure 6) Be careful to not penetrate the drill bit beyond the frame material (aluminum or PVC). Drilling too deep may damage the glass or the glass seal. Drill just deep enough to create a 1/4 inch hole for the pin to engage. 4. …
-
25, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 25 MAIN CIRCUIT BOARD MAIN WIRE HARNESS & SENSOR CABLE LIFT CABLE POSITION SWITCHES (PART OF MAIN WIRE HARNESS) SLIDING DOOR PANEL RIGHT POWER PLUG (PART OF MAIN WIRE HARNESS) MICROPHONES (PART OF SENSOR CABLE ASSEMBLY) LEFT POWER PLUG (PART OF MAIN WIRE HARNESS) LOCKING PIN CA…
-
5, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 5 Your POWER PET door package includes: • One Pet Transmitter Collar (Model MS-4 or MS-5 Ultrasonic Transmitter Collar) • 110 volt AC Adapter (connects to either Power Input Jack on edge of inside frame) • Pre-Fabricated Outside Frame • All Required Hardware (Wall Adapter Tunnel, Rechargeable Battery, Battery Charger Kit and Extra Transmi…
-
6, ___________________________________________________________________________________________ 6 www.hightechpet.com High Tech Pet Products, Inc. INSTALLATION POWER PET Electronic Pet Door Sliding Glass Insert High Tech Pet has incorporated their amazing fully automatic POWER PET door into a stylish sliding glass door panel that can be easily installed right alongside your exising sliding glass door. Your sliding glass POWER PET door is pre-installed in the sliding glass insert, which means your installation takes just minutes. 1. …
-
16, ___________________________________________________________________________________________ 16 www.hightechpet.com High Tech Pet Products, Inc. PET COLLAR OPERATING INSTRUCTIONS Your POWER PET DOOR comes with a standard model MS-4 or MS-5 ultrasonic transmitter collar. Each collar includes a battery TEST button which illuminates a red LED when the battery is OK. If the LED fails to light, battery replacement is necessary. Note: To energize the MS-4 Collar, pull out and discard the PULL TAB which is protrud…
-
4, ___________________________________________________________________________________________ 4 www.hightechpet.com High Tech Pet Products, Inc. POWER PET doors increase home security with a special automatic, dead- bolt locking feature that guards against would-be intruders. Only the coded signal from your pet’s collar will open the Power Pet door. Only Power Pet doors feature an ingenious directional sensing system that operates a fully automatic, motor driven panel. The signal emitt…
-
20, High Tech Pet Power Pet ___________________________________________________________________________________________ 20 www.hightechpet.com High Tech Pet Products, Inc. WATER RESISTANCE The High Tech MS-4 ultrasonic transmitter collar is water resistant meaning that rainy weather and humidity will not damage the unit. These collars are NOT designed to be fully immersed in water. Should this occur, simply open the unit, shake out water…
-
17, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 17 ADJUSTING THE STRAP 1. Fasten the collar around your pet’s neck so that it ts comfortably. In most cases there will be excess strap length. 2. With a soft pencil or magic marker, mark the amount of strap to be removed leaving at least one inch past the D-ring buckle. 3. Remove the collar from your pet and cut off the excess str…
-
26, NOTES _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________…
-
14, ___________________________________________________________________________________________ 14 www.hightechpet.com High Tech Pet Products, Inc. 1. Press OFF button 2. Press and hold one or both sensor buttons to select hold up time 3. Press OFF button to save this hold up time 4. Press ON button to power the door. When shipped from the factory the hold up time is set to 4 seconds. We recommend you initially introduce your pet to the door with a long hold up time. Later you can reduce the hold up tim…
-
13, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 13 Adjusting the Range When you rst install the POWER PET PX door, pre-set both RANGE Controls - one at a time - to the desired activation distance as fol- lows: - Enable just the INSIDE or OUTSIDE sensor and set that RANGE control to zero. - Hold the collar at about your pet’s height, pointing down toward the bottom of the door and at the desire…
-
28, Rev. II – 12/12/2012 px-sgl-manual ORDER INFORMATION To order extra collars and accessories please visit our website at www.hightechpet.com or call 1 (800) 255-1279 High Tech Pet Products, Inc. 2476 Palma Drive, Suite A Ventura, CA 93003 www.hightechpet.com
…
-
3, High Tech Pet Power Pet ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 3 INTRODUCTION Product Description: Your new POWER PET Electronic Pet Door is like no other pet door made. Patented POWER PET TM electronic pet doors are fully automatic, mo- tor driven and open completely under their own power. Activated by an ultrasonic pet collar, your new POWER PET door will keep out stray animals. It is secure ag…
-
9, High Tech Pet Power Pet ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 9 6. Position the lock with the pin extended into the 1/4 inch hole, and fasten the lock to the door using two supplied self tapping screws. (Figure 9) Operation: Pull the pin to allow open- ing of the door. Close the door and push in the pin to lock the door closed. Your High Tech Pet Fully Automatic Power Pet Door is now installed and ready for you and your pet to enjoy. FIGURE 9…
-
19, ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 19 REPLACING THE MS-5 BATTERY 1. Unscrew the bottom cover. 4. Remove and replace B3V1A battery 2. Pry bottom from top on ends and on edges using small at blade screwdriver 3. Remove bottom, note battery orientation 5. With new battery installed, close case. Squeeze …
-
12, ___________________________________________________________________________________________ 12 www.hightechpet.com High Tech Pet Products, Inc. binding or other restriction slows the door closure to the point that it un- necessarily retracts. See the AUTOMATIC SAFETY RETRACT Section for more information. AUTO DEAD BOLT LOCKING FEATURE The POWER PET door uses a spring loaded locking pin which automati- cally snaps into its retaining hole when the…
-
23, High Tech Pet Power Pet ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 23 TOTAL PET CONTROL ACCESSORIES: SOUND BARRIER Model SBR-1 Indoor Sonic alarm keeps your pet off furniture, away from the kitchen table or out of an entire room. Operated from your pet’s MS-4 or MS-5 transmitter included with your POWER PET Door. Also, operated by the optional RC-7000X collar. Order one for ea…
-
24, High Tech Pet Power Pet ___________________________________________________________________________________________ 24 www.hightechpet.com High Tech Pet Products, Inc. While opening, door stops rising and all lights turn off or blink Door panel goes up and down without stopping Very short range on both sensors Outside sensor good, but inside sensor yields short or no range Inside sensor good, but ouside sensor yields short or no range Manual button works, but in- side and outside sensors yield short or no range Manual…
-
15, High Tech Pet Power Pet ___________________________________________________________________________________________ High Tech Pet Products, Inc. www.hightechpet.com 15 AUTOMATIC SAFETY RETRACT: Your POWER PET PX is intrinsically safe for all pets and people, including small children. The door panel weighs less than 2 lbs. and is closed smoothly by gravity (not the motor) and is too light to cause any physical injury. However, just to be doubly safe around infants, we’ve included an automatic safety retract feature. Th…
