Monogram ZDWC240NBS Installation Instructions Manual

1, Monogram. We bring good things to life. ® If you have questions, call 800.626.2000 or visit our website at: www.monogram.com Installation Instructions Wine Chiller ZDWC240NBS and Beverage Center ZDBC240NBS Design Guide With Installation Instructions …

2, Monogram ZDWC240NBS Safety Information WARNINGS: • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the wine chiller or beverage center before cleaning or making repairs. • Repairs should be made by a qualified service technician. ATTENTION: • Il ne faut utiliser cet appareil que pour l’usage pour lequel il a été construit. • Il faut réparer ou remplacer immédiatement t…

3, Design Guide THE INSTALLATION SPACE The cutout depth must be 24" The cutout dimensions shown allows for a full door swing and access to the pull-out racks when installed as a built-in. • The wine chiller and beverage center can be installed freestanding. • If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be needed on hinge side. The filler strip will act as a spacer between the wine chiller case and adjacent cabinet door swing. The width of …

4, Monogram ZDWC240NBS Installation Instructions 4 TOOLS REQUIRED • #2 Phillips screwdriver • 1" open-end wrench • Torx screwdriver • Flat edge tool HARDWARE SUPPLIED • Monogram Badge • Hardware for changing door swing GROUNDING THE WINE CHILLER AND BEVERAGE CENTER IMPORTANT - (Please read carefully) FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of …

5, Installation Instructions STEP 2 REVERSE DOOR SWING SKIP THIS STEP IF DOOR SWING SUITS THE INSTALLATION Parts Included: • Top left case hinge • Bottom left door hinge Tools Needed: • Phillips Screwdriver • Torx Screwdriver–For case hinges Note: All parts will be reused except for bottom door hinge and top case hinge. To remove the door: • Remove 2 screws holding toekick. • Remove hinge plug cover on top left side of cabinet. • Flatten the shipping carton to use as a pad for the door. • Remove the 3 screws holding t…

6, Installation Instructions 6 STEP 3 LEVEL • Use a 1" open-end wrench to turn the leveling legs and raise or lower the product. • Adjust carefully, the wine chiller or beverage center should be level and plumb with cabinetry, and should align with adjacent toekick height. STEP 5 SLIDE PRODUCT INTO THE CUTOUT • Carefully, slide the wine chiller or beverage center into the opening. Be careful not to entangle power cord. • Make certain…

8, TEMPLATE FOR BADGE LOCATION ON ALL UNITS To position badge: • Cut template along dotted line. • Hold or tape template behind glass door so that it is visible from the front side. • Remove backing from badge. • Place badge onto front side of door, matching illustration on the template. IMPORTANT: Badge must be placed on the opposite side of the door handle. Note: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in…