Oce BLM 500 Operating Information Manual

17, 17 Stacker adjustment Stacker adjustment Adjust the Stacker Adjust the stacker according to the size and thickness of the finished bookAdjust the Stacker on page 45. …

23, 23 The Job Mimic The Job Mimic Introduction The job mimic shows the current machine status. Illustration [6] [6] The Job Mimic Component - function table [8] No. Icon Information 1 [7] The following items are shown ■ the size of paper ■ the format of the paper in the gathering …

43, Oce BLM 500 43 Empty the Trim Bin Empty the Trim Bin Introduction [19] [19] Trim Bin Open. [20] Note: The Booklet maker operates with the trim bin removed for a short period of time. The printer waits while the trim bin is removed, then continues when the trim bin is replaced. To prevent los…

105, 105 Lubricate the Stitch Head 3 Apply 30 mm of grease to the visible surface of the driver bar figure 62 on page 103 [63] [64] 4 Re-fit the wire-holder. 5 Lower the Booklet maker main deck. 6 Lower the clincher frame. (see ‘Lower the Clincher Frame’ on page 39). 7 Close …

92, 92 Chapter 6 Maintenance Clean the Static Elimination Bars Clean the Static Elimination Bars Introduction Clean the static elimination bars every week. This action extends the performance and service life of the static elimination bars. The Booklet maker is supplied with a small brush. Use the br…

73, 73 Clear Paper Jams [34] Step Action Information 1 Open the Booklet maker main deck 2 Remove the trim bin. 3 Loosen the trimmer infeed conveyor. The procedure can be seen from the top of the machine. Access to the parts is through the former-clamp mechanism. Hold the shaft an…