Binder KBF P 240 Translation Of Original Operation Manual

86, KBF P + KBF LQC + KBWF (E6) 11/2016 page 86/189 “Change program name” menu. In the field “Course” select the desired setting “Ramp” or “Step” and press the Confirm icon. 11.6.2 Weekday Section view. In the field “Weekday” select the…

149, KBF P + KBF LQC + KBWF (E6) 11/2016 page 149/189 In case of power failure, transmission of the alarm via zero-voltage relay outputs remains active for the duration of the power failure. Afterwards, both contacts will close automatically. When using the communication software A…

4, KBF P + KBF LQC + KBWF (E6) 11/2016 page 4/189 11.5 Section editor: Section management ................................................................................................ 83 11.5.1 Add a new section ...................................................................…

93, KBF P + KBF LQC + KBWF (E6) 11/2016 page 93/189 12.1.3 Alarm messages Condition Alarm message Start after condition occurred Zero-voltage relay alarm output (option) The current actual temperature value is outside the tolerance range (chap. 12.4) Temperature range a…

42, KBF P + KBF LQC + KBWF (E6) 11/2016 page 42/189 5.4 Operating modes The MB2 program controller operates in the following operating modes: • Idle mode The controller is not functional, i.e., there is no heating or refrigeration and no humidification or dehu- midification. The f…

112, Binder KBF P 240 KBF P + KBF LQC + KBWF (E6) 11/2016 page 112/189 14.5.3 New password assignment for “service” or “admin” authorization level when the password function was deactivated If the password protection for an authorization level has been deactivated, i.e., no password is ass…