Altronix eBridge8E Installation Manual

6, www.altronix.com - 6 - eBridge8E Configuring eBridge8E units for network connection: Since every Network Configuration is different, please check with your Network Administrator to see if your eBridge8E unit should use static IP addresses, or DHCP assigned IP addresses and/an Inbound Port assign…

5, www.altronix.com - 5 - eBridge8E User Interface and Programming: Note: A constant PC connection is not required for proper operations and is used as a local programming/monitoring tool only. Please note that all interconnecting equipment shall be UL Listed. Step 1. Set Local Area Connection …

10, www.altronix.com - 10 - eBridge8E B A C Mounting Hardware (Included): Two (2) mounting brackets Six (6) flat head screws for mounting brackets. Four (4) rubber pads. Mounting Options: Rack Mount Installation 1- Remove and discard factory installed screws from both sides of rack chassis (Fig.…

12, www.altronix.com - 12 - eBridge8E Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056 website: www.altronix.com, e-mail: [email protected]. Lifetime Warranty, Made in U.S.A. IIeBridge8E H29P MEMBER No…

3, www.altronix.com - 3 - eBridge8E Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condit…

1, Altronix eBridge8E Ethernet over Coax Solutions Installation Guide Models Include: eBridge8E - Eight (8) Port EoC Receiver with Integral PoE+ Switch Rev. 081716 More than just power.™ …