Minicom 1VS21004 Operation & User’s Manual

13, 12 14. Operating the UTP VGA Splitter system To prepare the system for operation: 1. Connect the system. 2. Switch on the computer, Central Unit, Remote Units and remote display monitors. The computer screen image broadcasts to all the Remote unit locations. Adjusting …

3, 2 1. Welcome Thank you for buying the UTP VGA Splitter system. This system is produced by Minicom Digital Signage. Technical precautions This equipment generates radio frequency energy and if not installed in accordance with the manufacturer's instructions, may cause radio …

2, Minicom 1VS21004 1 Table of Contents 1. Welcome 2 2. Introduction 3 3. The system components 3 4. The Central Unit 5 5. The Remote Long Range Unit 5 6. The Remote Short Range Unit ports 6 7. The cables 7 8. Connecting the System cables 7 9. Connecting the Screen cable 8 10. Connecting …

9, 8 9. Connecting the Screen cable The Screen cable connects the Central Unit to the computer. To connect the Screen cable: 1. Connect the HDD15M connector to computer’s video card. 2. Connect the HDD15F connector to the Central Unit 's Video In port. 10. Connecting…

6, 5 4. The Central Unit The figure below illustrates the Central Unit front panel. The figure below illustrates the ports on the Central Unit 2 Port rear panel. Power connector Screen cable to computer System cables to Remote units LOCAL MONITOR VIDEO IN TO REMOTE UNITS 1…

4, 3 2. Introduction With the UTP VGA Splitter system, broadcast your computer's VGA screen to four remote monitors simultaneously. Broadcast up to 250m/820ft using CAT5 cables. The UTP VGA Splitter system is compatible with VGA, SVGA, or XGA video standards 3. The system comp…