MINOLTA-QMS Magicolor 2200 DeskLaser Operator's Manual

182, 13. Wipe the transfer area clean with the dampened cloth. The transfer area consists of the following components: • The movable transfer guide (with green handle) and clear plastic strip • The metal transfer roller • The silver-colored metal transfer guide MLO-004872 (Figure 7-37; 16 pica…

96, MINOLTA-QMS Magicolor 2200 DeskLaser Table 4–6 (Cont.): Changing and Saving Values Operation Display Reads 6. Press until the value equals -10.0. NOTE: The value decreases in steps of 0.5. offsetX -1 0.0 7. Press Enter to enter the new value. offsetX =-10.0 (momentarily) offsetX offsetY 8. Press once to scroll the …

169, 6. Clean the discharging pins (in the groove) using the brush end of the cleaner. CAUTION: You must lift the brush over the separation wires as you clean along the groove. Be careful not to break the wires as you clean the discharging pins. MLO-004876 (Figure 7-21; 20 picas) Maintenance 7–17…

14, Associated Documents Several other related manuals are available for use with the DEClaser 2200 printer. You can order these optional manuals from DECdirect as described in the ordering information section at the end of this guide. Those optional manuals are: • Digital ANSI-Complia…

162, 6. Remove the wire/pin cleaner from the inside of the printer. WARNING: Be careful when removing the wire/pin cleaner from the printer, because the fixing assembly may be hot. MLO-004873 (Figure 7-11; 16 picas) 7. Insert the felt end of the wire/pin cleaner into either end of the EP-S cartri…

43, 2.8.1 Adding Paper to the Cassettes Add paper to the cassettes using the following procedure. 1. Check to see that the printer is not printing and that the display reads 00 READY before you remove the paper cassette. If the printer has run out of paper, the display reads 11 PAPER OU…