OHAUS Ranger Service Manual

6, ii 3.2.6.5 How to Save and Store an Individual Menu Item .............3-15 3.2.6.6 How to Quit the Menus ....................................................3-15 3.2.6.7 Calibration Menu .............................................................3-15 3.2.6.8 Setup Menu ...............…

53, OHAUS Ranger 3-33 CHAPTER 3 MAINTENANCE PROCEDURES 3.3.5.2 Replacing the Display Mounting Plate Note: In order to replace the display mounting plate, the keypad membrane must be removed. This cannot then be reused and must also be replaced. • Remove keypad membrane. • Push the 3 cantilever sn…

65, 4-3 CHAPTER 4 DATA TABLES 4.1.3 Overview of Weighing Cells and Preloads TABLE 4-3. STRAIN GAUGE WEIGHING CELLS Ranger Weighing pan Weigh- Replacement Preload Preload Total of load Mechanical Preload reserve Cellcapacity model (mm) ing …

59, 3-39 CHAPTER 3 MAINTENANCE PROCEDURES 3.3.9.5 Working in Service Mode (Cont.) Specifying weighing range If the analog PCB is replaced, it is necessary to specify the weighing range, because the EEPROM on the PCB is set to a default value at the factory (15 kg dual-range scale). It i…

23, 3-3 CHAPTER 3 MAINTENANCE PROCEDURES Loc Cal ON, OFF quit Setup ON, OFF quit Read ON, OFF quit RS232-1 ON, OFF quit RS232-2 ON, OFF quit Locset ON, OFF quit Endloc quit Store ? rs232-1 Com 1 reset YES, NO Mode Print, On Stb, Stb only, Cont, Dialog, Disp 2, Ref 2, Bulk2 quit baud 300,600,1200, 2400…

33, 3-13 CHAPTER 3 MAINTENANCE PROCEDURES 3.2.4.11 Lockout Menu Function/Display Available Settings Application This menu allows software locking and unlocking of the calibra- tion, setup, read, RS232-1, RS232-2, menus. Turning individual menu locks ON and OFF prevents accidental cha…