Sierra Wireless AirLink ES Series Hardware User's Manual

32, AirLink ES Series Hardware User Guide 32 4116746 For installations that require the gateway to be turned on/off, Sierra Wireless recommends using the Ignition Sense (Pin 3) input for that purpose. • Pin 2—Use the black wire in the DC cable to connect Pin 2 to ground. See also Grounding…

44, AirLink ES Series Hardware User Guide 44 4116746 Host Interfaces • 10/100 Base-T RJ-45 Ethernet • RS-232 Serial port (DCE, requires null modem for console connection) • USB V2.0 Micro-B connector • 2 SMA antenna connectors (Primary, Secondary) • Active antenna support P…

49, Sierra Wireless AirLink ES Series AirLink ES Series Specifications Rev 4 Aug.15 49 The maximum input current is 500 mA at 100–240 VAC. The inrush current will not exceed 70 A at 100–240 VAC input and maximum load from a cold start at 25°C. AC Power Adapter Output AC Power Adapter Environmental Conditions AC Power Adapt…

53, Rev 4 Aug.15 53 A A: Acronyms Table A-1: Acronyms Acronym or Term Definition 1xEV-DO Single Carrier (1X) EVolution — Data Only A high-speed standard for cellular packet data communications. It supports Internet connections with data rates up to 3.1 Mbps. (downlink from th…

29, On-site Installation and Setup Rev 4 Aug.15 29 For simple installations in good LTE coverage, an Ethernet-connected configuration PC running your favorite speed-test application and ACEmanager to determine network signal strength, cell info, and signal quality will help narrow down some of …