Pro'sKit MT-2017 Operation & User’s Manual

1, MT-2017 Protective Function Analog Multimeter User’s Manual 1 st Edition , 2011 ©2011 Copyright by Prokit’s Industries Co., Ltd. 1 INTRODUCTION This Multi-meter is an accurate, safe, battery operated, rear tilt-stand, easy to operate handheld instrumen…

2, 4 CALIBRATION Ohms Zero Adjustor located at the right side of the panel, adjusting the meter pointer to the Zero mark on the right side of Ohm scale of the meter dial when the test leads are touched together. Mechanical Adjustor Screw: located right below the center of t…

3, 8 The Maximum terminal voltage drop is 250mV except for the 10A range. Note: If connected incorrectly with the voltage at these ranges, quickly remove the test leads from the circuit as to avoid damage to this tester. (This tester can afford the voltage <250V DC/AC rms. for the …

4, Pro'sKit MT-2017 12 1. For Measuring the Capacitor over 25uF: 1) Set the selector switch to the R X 1K range. 2) Connect the BLACK test lead to the “-COM” jack and the RED test lead to the Red “+” jack. 3) Connect the test leads to the capacitor to be measured (Note the polarity of ca…

5, 16 規格表： 測試功能 檔位 準確度 說明 直流電壓 DCV 0-0.1-2.5-10-50-250-1 000V ±3%FSD(滿刻度) ±4%FSD(1000V 檔) 輸入阻抗：20KΩ/V 超載：Max 1000V 但在 0.1V/2.5V/10V 各 檔，250V Max. 正負直流 電壓 Null DCV DC ±5V/±25V ±5% FSD.(滿刻…

6, 20 5. 電阻：(※此功能不能測試帶電壓電路) 測量電阻值和測試線路和線路間的連通性。5 個檔中的每一個 檔位元標記，分別表示該檔乘數。(K 即 X1000) 注意：本機在電阻檔具有防誤測保護電路。可短時（5 秒…