Pulnix TM-1010 Operation & Maintenance Manual

13, 13. DIGITAL CABLE ASSEMBLY 30DG-02-10 (10-bit cable) P/N 50-1301-10 for TM-1010 Full function cable 1 16 17 31 TM-9700 31-pin connector 1 19 2037 37-pin D-SUB connector rear view Pin Signal Cable 1 CLK+ OR 1RED 2 LDV+ GRY 1RED 3 FDV+ WHT 1RED 4 GND YLW 1RED 5 HD PINK1RED 6 D0+ OR 2RED 7 D1+ …

11, Pulnix TM-1010 10. Digital output pulses Digital Video Differential line-driven, 10-bit parallel signal with EIA-422 format. 100Ω output termination impedance. Output from 31-pin connector. The mating connector: Airborne MP211-031-113-4300 Please consult digital cable information. eg. 50-130…

12, 11. Connector and cable Digital output connector is optional. Mating connector ordering information: PULNiX part No. 15-1623 Airborn P/N: MP211-031-113-3400 Straight Backshell (cover): 15-1624 MM254-031-000-0000 Cable assembly: Digital cable 30DG-02-10 50-1301-05 12-pin connector and c…

15, 14-7. Command W Function: Write data to the selected pages or calibration data table. 14-7-1 Saving to page (from page 9 through F) STX, “W”, “A” - “F”, ETX 02H, 57H, 41H - 46H , 03H (“page 9” is factory use only) 14-7-2 Saving to calibration table “WU” command…

9, 8. Frame Memory The TM-1010 has a built-in frame memory which outputs progressive scanning images at 15 Hz rate (15 frames per sec). This feature provides the following advantages: 1. Asynchronously captured images are output as standard continuous video signals so that a monitor or …