Tannoy CMS801 DC BM Installation Manual

2, 2 CONTENTS 3 INTRODUCTION 1 UNPACKING 2 PRODUCT FEATURE IDENTIFICATION 3 ACCESSORIES 4 INSTALLATION GUIDE 5 MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS MECHANICAL INSTALLATION GUIDE FOR SHEET-ROCK CEILINGS MECHANICAL INSTALLATION INSTRUCTIONS FOR OPTIONAL PLASTER RING INSTRUCTIONS FOR OPTIO…

4, DO NOT OVERTIGHTEN! 6 5.1 MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over the railings, supporting the weight of the speaker. 5 Slide the speaker assembly through the hole and turn the screws…

5, 8 9 5.4 INSTRUCTIONS FOR OPTIONAL PRE-INSTALLATION BACK-CAN (PI MODELS ONLY): Attach the back-can to the installed conduit This can be attached in two ways: 1 Go to section 6 for instructions on wiring and setting up then return to point 5 below. 4 Cut out the hole in the ceiling using a circular sa…

8, Tannoy CMS801 DC BM 14 15 9. PAINTING If desired, the grille and baffle panel may be painted to match the surrounding décor. Painting the baffle: Carefully mask off the driver assembly using the paint-mask provided to ensure that the paint does not come into contact with the cone and roll surround. App…

3, 4 5 4. PRODUCT FEATURE IDENTIFICATION: Note that the CMS801 DC PI model’s transformer is pre-attached to the CMS801 DC back-can for easy install. Fig 1.1: The blind-mount (BM) models come with a pre-fitted back-can Fig 1.2: A pre-install (PI) model shown without optional pre-install ba…