Think & Tinker ModuLam 130 Operator's Manual

14, ModuLam 130 Operators Manual page 12 Fold the stripped release liner under the film. Feed the carrier (or copperclad) into the laminator and let about 1/2" pass between the rollers. If you are using a Modulam laminator, step on the footswitch to stop the feed m…

13, Think & Tinker ModuLam 130 ModuLam 130 Operators Manual page 11 Attach two pieces of Scotch ® tape on opposite sides of one corner of the photopolymer. Using a quick pull, break the dull, matte release liner away from the adhesive side of the photopolymer (photoresist or soldermask). Peel…

17, ModuLam 130 Operators Manual page 15 Specifications ModuLam 130 Height (mm) 140 Width (mm) 580 Depth (mm) 295 Max. laminating width (mm) 330 (13") Max. laminating speed (cm/min) 105 Max. operating temp. 140°C Warm-up time approx. 3 min Control system microprocesso…

12, ModuLam 130 Operators Manual page 10 Appendix Laminating Photoresist and Soldermask The Modulam Hot Roll laminator is available with an optional foot switch and lamination carrier that make the application of dry-film photopolymers and pressure sensitive adhesives straight forward an…

7, ModuLam 130 Operators Manual page 5 B. Preset functions A number of pre-programmed combinations of temperature and roller speed are accessible from the control panel. These should provide good starting points when laminating new materials and will shorten the learning curve as you …