A&D FZ-120iWP Instruction Manual

44, 42 9-5 Description of the Item “Data Output Mode” The parameter setting of the “Data output mode ( prt )” applies to the performance when the data is transmitted using the RS-232C serial interface. Key mode When the PRINT key is pressed with the stabilization indictor turned on…

21, 19 5-3 Percent Mode (%) This is the mode to display the weight value in percentage compared to a 100% reference mass and is used for target weighing or checking the sample variable. Selecting the percent mode 1 Press the MODE key to select % (percent mode). Storing the 100%…

1, FZ-120iWP / FZ-200iWP / FZ-300iWP FZ-1200iWP / FZ-2000iWP / FZ-3000iWP FX-120iWP / FX-200iWP / FX-300iWP FX-1200iWP / FX-2000iWP / FX-3000iWP 1WMPD4001591A …

50, 48 9-10 Clock and Calendar Function The balance is equipped with a clock and calendar function. When the “GLP output (info)” parameter is set to “1” or “2” and the “Time/Date output (5-td)” parameter is set to “1”, “2” or “3”, the time and date are added to the…

30, A&D FZ-120iWP 28 7. CALIBRATION 7-1 Calibration Mode The FZ-i WP series and the FX-i WP series balance has the following two modes. Calibration using the internal mass (One-touch calibration, only for the FZ-i WP series) Calibration using an external weight Calibration test using an ex…

46, 44 KF format 5if type 2 This is the Karl-Fischer moisture meter format and is used when the peripheral equipment can only communicate using this format. This format consists of fourteen characters excluding the terminator. This format has no header characters. The polarity si…