Olivetti d-Copia 1600 Service Manual

97, 2HA/2HB 1-4-1 1-4 Troubleshoo ting 1-4-1 Paper misfeed detection (1) Paper misfeed indication When a paper misfeed occurs, the copier immediately stops copying and displays the jam location on the operation panel. Paper misfeed counts sorted by the detection condition can be checked in maintenance …

32, Olivetti d-Copia 1600 2HA/2HB 1-2-12 8. Connect the 4-pin connector of the key counter to the key counter wire. 9. Engage the projection of the key counter mounting plate with the aperture of the right cover. 10. Secure the key counter cover and the key counter mounting plate together with the copier …

147, 2HA/2HB 1-5-21 8. Remove the two screws holding the exit unit and then pull out the unit a little. Figure 1-5-46 9. Remove the exit tray. Figure 1-5-47 10. Remove the four screws and detach the two connector and then remove the laser scan- ner unit. 11. Replace the laser scanner unit and refi…

136, 2HA/2HB 1-5-10 7. Temporarily push the MP paper feed pulley unit into the rear side to unlock the front side and then remove it from the copier. Figure 1-5-18 8. Remove the MP paper feed pulley from the MP paper feed pulley shaft. Figure 1-5-19 9. Push the fitting portions of the MP s…

72, 2HA/2HB 1-3-40 U251 Checking/clearing the maintenance count Description Displays, clears and changes the maintenance count. Purpose To check the maintenance count. Also to clear the count during maintenance service. Method 1. Press the start key. 2. Select the item using the exposure ad…

154, 2HA/2HB 1-5-28 1-5-7 Fuser section (1) Detaching and refitting the fuser unit Follow the procedure below to replace the fuser unit. Procedure 1. Open the front cover and left cover and then remove the inner cover. 2. Insert a flat-blade screwdriver or the like through the groove at the l…