Otto Bock Start series Operation & User’s Manual

21, 53 6.9 Adjusting the height of the armrest for desk side panel The armrest can be set to three different heights. In the standard assembly, the armrest is moun- ted firmly onto the tube bend. INFORMATION! To increase the armrest height, remove the two cap screws completely from the tube bend. Then …

16, 48 24 25 A B B A 6.2 Changing the wheelbase Shifting the rear wheel backwards lengthens the wheelbase and thus provides for greater sta- bility of the wheelchair. Shifting the rear wheel forwards (only for advanced wheelchair drivers!) relieves the load on the casters. This increases th…

23, 55 6.13 Adapting the back upholstery (Fig. 33) If you have selected the option “adaptable back upholstery”, you can adjust the back upholstery in segments according to your needs. INFORMATION! To do this, remove the back upholstery padding and undo the hook-and-loop fas- teners of …

7, Otto Bock Start series 39 DANGER! Using your Otto Bock product as a seat for transportation in motor vehicles for disabled passengers Whenever possible, users should be transferred to the seats installed in the motor vehicle for disabled passengers. The corresponding restraint systems should also be used. Only t…

27, 59 Mounting (Fig. 36) • Place the protective rim band over the valve. Then push the valve through the rim. Screw on the valve nut, if there is one. The rim band can then be easily applied. • Ensure that all spoke ends are covered. Tires (Fig. 37) • Beginning behind the valve, plac…