Outback Sapphire 2 Burner Assembly And Operating Instructions Manual

22, 22 Burner Removal To remove the burners (see photos): 1. Remove the burner retaining clip from underneath the burner support. 2. Remove the cross channel lighter bar from the burner. 3. Lift the back of the burner upwards and pull away from the opening and the gas valve at the front of t…

8, Outback Sapphire 2 Burner 8 Attach the Gas Bottle Holder (C14) to the Bottom Slat Assembly (C12) using the Screws (D2) and Washers (D3). Insert the axle (C19) through the clamping brackets on the gas bottle holder (C14) and tighten the clamp screws. Take care not to over tighten these screws which will…

14, 14 Lay the Utensil Trays (C5) into their positions on either side of the barbecue body. Place the Wheel Hubcaps (C16) onto the sides of the Wheels (C17) 20 19 …

7, 7 Align the Gas Bottle Holder (C14) with the Slat Assembly (C12). Attach the Front Left Leg (C8) and Rear Left Leg (C9) to the Gas Bottle Holder (C14). Note: Threaded inserts must be facing in the direction shown! Threaded Insert 6 5 …

10, 10 CAUTION! Care must be taken to ensure hood does not fall open unexpectedly or that the hood surface is damaged when set on the ground. Carefully turn the Barbecue Body (B1) upside down and remove the Drip Tray (B5). Attach the R/H Side Shelf (C6) to the Barbecue Body (B1) using the Screws (…

23, 23 Cleaning Material Where used Cleaning Method Recommended Stainless Centre hood panel Clean using hot soapy water or with the use of a suitable Steel cleaning product following th…