Sagem MF9300 Scanner Manual

24, 22 HOW TO USE THE NETWORK SCANNER FUNCTION TRANSMISSION METHODS FOR SCAN TO E-MAIL The destination for a Scan to E-mail transmission can be selected from the address book or entered manually. You can also use an e-mail address stored on an LDAP server. It is possible to select multiple destinati…

17, 15 BEFORE USING THE NETWORK SCANNER FUNCTION 1 STORING THE SENDER INFORMATION (Scan to E-mail) Use this procedure to store the sender information (sender name and e-mail address) that appears when you send an image by Scan to E-mail. Up to 200 senders can be stored (only one sender can be select…

41, 39 4 INSTALLING THE SOFTWARE PROGRAM Note the following when installing the software program from the "Network Scanner Expansion kit" CD-ROM: ● Be sure to check the system requirements for installation of each of the software programs in the user's guides and on the informat…

30, 28 HOW TO USE THE NETWORK SCANNER FUNCTION SELECTING THE RESOLUTION The resolution for scanning an original can be selected. Load the original in scanner mode and then follow the steps below. The factory default setting for the resolution is "300 dpi". Change the resolution 1 …

25, 23 HOW TO USE THE NETWORK SCANNER FUNCTION 2 Sending an image by selecting an e-mail address in an LDAP server To use an LDAP server, the LDAP server settings must be configured in the Web page. 1 Perform steps 1 through 6 of "BASIC TRANSMISSION METHOD". (p.20) 2 Touch the [ADDRES…

40, Sagem MF9300 38 Network Scanner Expansion kit CD-ROM USER'S GUIDES FOR SOFTWARE PROGRAMS The Manual folder in the "Network Scanner Expansion kit" CD-ROM contains user's guides (in PDF format) for each of the software programs. • Companion Installation Guide • Companion User's…