Salicru SPS SOHO+ series Operation & User’s Manual

10, Salicru SPS SOHO+ series 10 3.2. Synoptic with LCD display. As it is possible to be observed in the following figure, the equip- ment has a standart LCD display, where are reflected the input tension and frequency, output voltage and frequency and the fault indicators, load level, battery capacity, line and battery mo…

13, 13 SALICRU 5. OPERATION. 5.1. Preliminary controls. • Make sure that all connections have been done properly, and respecting the labelling of the equipment and the instructions of chapter 4. • Check that the power supply is correct. • Check that the SPS is Off (shutdown). •…

7, 7 SALICRU For an optimum and efficient operating, the battery set has to be located as close as possible to the equipment. • The battery voltage can involve the risk of electric shock and can produce high short circuit currents. Ob- serve the following preventive measures before man…

11, 11 SALICRU 4. Installation. • Check the Safety instructions, from section 1.2.3. • Check that the data in the nameplate are the required by the installation. • A wrong connection or manoeuvring, can make faults in the SPS and/or loads connected to itself. Read carefully the in- …

14, 14 • Battery capacity definition: Battery bar indication Battery voltage ≤ 11 V 11 V ≤ Battery voltage ≤ 11,5 V 11,5 V ≤ Battery voltage ≤ 12,5 V Battery voltagea ≥ 12,5 V Battery level Table 2. Battery level. • When over load, the mark will flicker every 1 second.…