OTARI MX-5050mkIV-2 Operation And Maintenance Manual

41, 6.6 Tape Speed Adjustment Tape speed is adjusted by measuring the tape speed using a special test tape, and then adjusting the speed to bring it into the desired range. Tape speed should be adjusted at the normally used tape speed. Also, since tape tension affects tape speed, to accura…

16, 3.2 Transport Control Panel EDIT ON OFF SPEED MODE EXT FIX VARI PITCH CONTROL POWER DOWN UP SPEED L H CUE SET ZERO 1 2 3 REPEAT CLR TIME-IPS-% SEARCH H M S H L TAPE SPEED SET ZERO 1 2 3 REPEAT CLR TIME·IPS·% SEARCH H M S H L TAPE SPEED REEL SIZE S L S L SUP T.UP 1 11 10 12 13 15 16 17 …

21, [1] LINE OUTPUT Connector These XL type connectors are for audio output. See §2.2.2 for pin assignment. [2] LINE INPUT Connector These XL type connectors are for audio input. See §2.2.2 for pin assignment. [3] Microphone Input Connector These XL type connectors are for microphone input. […

51, 7.4 Record Electronics Adjustments 7.4.1 Record Bias Level Adjustment 1. Thread the machine with the tape normally used for sessions. 2. Press down the RECORD READY button to the READY position and set the Monitor button to SOURCE position. Set the SPEED HI/LO switch to the Hi…

38, OTARI MX-5050mkIV-2 6.4 Capstan Motor Adjustment and Pitch Control Adjustment 1. Open the rear panel by removing the screws on the rear panel. 2. Turn on the machine, and load the tape on the machine. Make sure that the Tape Speed mode is set to the FIX. 3. Set the Speed Select button to 15 ips (HI …

17, [9] CLR Button Pressing CLR together with the one of the following keys works as follows. CLR + SET: Exits Set mode CLR + TIME·IPS·%: Tape Timer Display resets to zero CLR + SEARCH 1-3: Clears Cue Point Memory CLR + REPEAT: Exits Repeat mode [10] Speed Mode Select Button This …