Pakedge SX-24P Quick Start Manual

9, Pakedge SX-24P 9 4. To set ports with the ability to only access a single VLAN, click the VLAN you want to use under “Access”. Then click on the ports above you wish to set with that VLAN. Once you have the ports you want selected, click Apply at the bottom of the page to save those settings. 5…

7, 7 The Pakedge Zone wizard oers the simplest way to individually congure all switch ports with the specic VLAN settings required for the network. The wizard provides a step-by-step guide through the conguration process. Pakedge Zone & VLAN Setup New to the SX Series switches ar…

12, pakedgedevice&software inc 3847 Breakwater Avenue Hayward,CA 94545 Main: 650-385-8700 Fax: 650.685.5520 www.pakedge.com [email protected] Technical Support Please visit our website for up to date support information. Web: www.paked…

11, 11 You can reset the IP address of the switch through the console. This can be helpful in case of miss- conguration. To do this you will rst need to console into the switch as previously described and then take the following steps: 1. Type show ip and press enter to see the current IP addr…

1, QUICK START GUIDE SX-24P Enterprise-Class, Fully Managed Gigabit Switch with 24 PoE+ Capable Rear Facing Ports Version 1.0 pakedgedevice&software inc …

5, 5 1. Connect the SX-24P to a power source. The PWR LED will light up and the fans will start. 2. Connect a PC or laptop to any LAN port on the switch. 3. Congure the PC with a static IP address of 192.168.1.10 and subnet mask of 255.255.255.0 (Default Gateway and DNS can b…