Mul-t-lock Entr Operation & User’s Manual

18, 18 Page ENTR™ User Manual 5.6 Open door 5.7 Lock door 5.3 Touchpad Reader master PIN code Touch screen with palm or ngers Press [11] [#] 1 Enter [New master PIN code] (4-10 digits) [#] For example: 1231234# 2 Reenter: [New master PIN code] [#] 3 5.4 Menu mode Entering menu…

7, 7 Page ENTR™ User Manual • Assemble the cylinder into the door unit (base plate & knob). • Tighten cylinder mounng screw. • Connect data cable plug • Assemble Electrical unit as illustrated • Tighten electrical unit panel screw Note: Verify that the cylinde…

11, 11 Page ENTR™ User Manual 3.2 Door conguraon The Door Conguraon process will determine the lock and door characteriscs. This process is done once aer compleng the installaon process of the lock. It will take 15-20 seconds to complete. Press [Cfg] 2 Numeric buons …

20, Mul-t-lock Entr 20 Page ENTR™ User Manual 6.1 Mounng the Fingerprint Reader Prior to starng, select the locaon where the Fingerprint Reader is to be mounted. • Aach the Fingerprint Reader base plate to the wall • Use 4 screws and screw anchors or double sided glued tape 6.2 B…

9, 9 Page ENTR™ User Manual • Turning the ENTR™ lock ON or OFF. 2.3.1 Switching the ENTR™ ON Before switching the ENTR™ ON verify that the door is shut. • Move the switch to ON posion. Make sure that the knob is in zero posion (see illustraon). • Funcon and numeric bu…

6, 6 Page ENTR™ User Manual • Sck the magnet to the door frame opposite and below (20mm) to the cylinder xing screw (M5 screw). • Use the double sided scker supplied. Note: The magnet area on door frame should be clean and free from dust, peeling paint etc. Use alcohol if r…