RADVision Scopia XT5000 Series Operation & User’s Manual

3, Table of Contents Chapter 1: About the Scopia XT Endpoint for IP Office Chapter 2: Getting Started Initial Workflow for XT Endpoint Users .............................................................................................................8 How to Control the XT Endpoint ..…

21, 4. Press 2 to align the bottom right corner. 5. Use the arrow keys on the XT Remote Control Unit to position the image, and then press ok/menu. 6. To configure network settings, select Next and continue with Configuring Network Settings on page 21. Configuring Network Settings…

47, By default, the system stores the last camera position and retrieves this position the next time the camera is switched on. You can store multiple camera positions for future use, as described in Administrator Guide for Scopia XT Endpoint for IP Office. For information about connecting the Sc…

59, Figure 42: Connecting the computer's audio to the XT Codec Unit 3. Continue with setting the display resolution, as described in Selecting the Computer Display Resolution on page 59. Selecting the Computer Display Resolution About this task For optimal display quality, and to…

50, RADVision Scopia XT5000 Series Figure 34: In-Call menu The icon appears on the display. To unmute, repeat the procedure described above. The icon disappears from the display. Important: The icon shows that the remote endpoint's microphone is muted. About Video Layouts A video layout is the arrangement of pa…

72, Moderating a Videoconference Hosted by Another Scopia XT Endpoint for IP Office About this task When you use the Scopia XT Endpoint for IP Office as an endpoint, you can moderate videoconferences hosted by another endpoint with a built-in MCU. This functionality is only available if: �…