Ransomes Highway 3 Safety, Operation & Maintenance Manual

33, en-31 6 CONTROLS 1234.5 BLOCKED CHARGE FILTER FAULT  A A 6.2H.5 WATER TEMPERATURE SCREEN __________________________________ If the temperature increases to 108°C, the RED LEDs (A) flash at a rate of two flashes every four seconds. The warning buzzer will sound at the same rate and the �…

60, en-58 8 MAINTENANCE & LUBRICATION B A 8.4 ENGINE COOLANT ____________________________________________________ Check Engine Coolant Level (a) The level of coolant in the expansion tank should be between the MAX and MIN level indicators when cold. (b) If topping up is required, remove…

85, Ransomes Highway 3 en-83 12 QUALITY OF CUT 12.4 SCALPING ________________________________________________________ NOTE: Arrow indicates direction of travel. Scalping is a condition in which areas of grass are cut noticeably shorter than the surrounding areas, resulting in a light green or even brown patc…

34, en-32 6CONTROLS 15 22° 6.2H.7 SLOPE WARNING SCREENS_______________________________________ NOTE Slope warning screens will only appear when TST is installed. During work if the machine is driven onto a slope of 16º the screen will display this warning which over rides all other informati…

52, en-50 7 OPERATION 7.12 TRANSPORTING ON A TRAILER ________________________________________ The machine is fitted with tie-down loops front (A) on hard point and rear (B). Always tie down the machine securely to the trailer. Always follow any recommendations for maximum trailer weights …

43, en-41 6 CONTROLS 7 8 X Y Z A 9 6.10 LIGHTING KIT (Optional)___________________________________________ Lighting control Stalk A Push away from operator to turn main beam on. B Pull towards operator to flash headlights. C Move stalk up to indicate right turn. D Move stalk down to indicate lef…