Razorweld KUMJRRW145 Operating Manual

10, 10 FRONT PANEL LAYOUT 1. Digital Volts Meter 2. Digital Amps Meter 3. 2T/4T Selector Button 4. Wire Speed / AmpsAdjustment Knob 5. Voltage / Downslope /ARC Force Adjustment Knob 6. MIG / TIG / MMA /Smartset Selector Knob 7. “-” Output terminal 8. Euro MIG / TIG Torch Connector (MIG/MAG) 9. �…

18, 18 (3) Connect weld power lead to (7) Place wire onto spool holder - (spool retaining nut is left hand thread ) Feed the wire through the inlet guide tube on to the drive roller. (6) Fit the correct sized Knurled Drive roller for Gas Less Flux Cored wire (2) Connect earth lead to (4)…

43, 43 1: Excessive Spatter Possible Reason Suggested Remedy Wire feed speed set too high Select lower wire feed speed Voltage too high Select a lower voltage setting Wrong polarity set select the correct polarity for the wire being used - see machine setup guide Stick out too long Bring the torch clos…

30, 30 Wire types and sizes - Use the correct wire type for the base metal being welded. Use stainless steel wire for stainless steel, aluminium wires for aluminium and steel wires for steel. Use a smaller diameter wire for thin base metals. For thicker materials use a larger wire diamete…

19, 19 Continued set up for MIG with Gasless wire for RAZOR 210 (7) Place the Wire Spool onto the Spool Holder - Note: the spool retaining nut is Left Hand thread. Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into the wire feeder in…

23, Razorweld KUMJRRW145 23 Installation set up of the Spool Gun for RAZOR 210 (1) Select Spool Gun using the Standard/Spool Gun selector switch. (2) Connect the Spool Gun to the Euro MIG torch connection socket on the front panel, and tighten it. Connect the Spool Gun control cable to the receptacle and…