Acces PCI-IDI-XX Operation & User’s Manual

13, Chapter 5: Programming The base address is assigned by the computer system during installation and will fall on an eight byte boundary. The card’s read and write functions are as follows: Address Read Write Base Address + 0 Port 0 Low Byte N/A Base Address + 1 Port 0 High Byte …

11, Chapter 3: Option Selection Each channel has a jumper configurable filter option. 3.90" 6.90" NO FILTER FILTER FLT0 FLT15 FLT16 FLT31 FLT32 FLT47 Figure 3-1: Option Selection Map Filter Response Switch Jumpers are used to select input filtering on a channel-by-channel b…

15, Acces PCI-IDI-XX Chapter 6: Connector Pin Assignments Isolated inputs are connected to the card via a 50-pin HEADER type connector. There are three connectors named PORT0, PORT1, and PORT2. The table below describes PORT0. PORT1 and PORT2 are identical pinouts. Pin 50 is located toward the Jumpers, …

12, Chapter 4: Address Selection This card uses I/O addresses offset from the base address assigned by the PCI bus. The address spaces are defined in the Programming section of this manual. PCI architecture is Plug-and-Play. This means that the BIOS or Operating System determines the …

5, Chapter 1: Introduction Features • Individually-Isolated AC/DC Inputs for up to Three 16-Bit Groups, 48 total. • Reverse Polarity protection • AC Filtering • Optical Isolation, Channel-to-Channel and Channel-to-Host PC. • Change-of-State detection (certain models). Descrip…

4, Table of Contents Chapter 1: Introduction................................................................................................. 5 Table 1-1: Model Versions....................................................................................... 6 Specification ...........…