Redlake MASD MegaPlus ES 1020 Operation & User’s Manual

22, MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 22 91000134-001 Rev. A Appendix B Strobe/Trigger/Power Cable WARNING: Always check the pin out of a custom cable before using it! The strobe/trigger accessory cable enables access to the …

11, MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 11 91000134-001 Rev. A 4. ES 1020 Camera Operations Manual The following section describes in detail the function of the cable connectors and LEDs located on the rear panel of the ES 1020. Camera …

7, MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 7 91000134-001 Rev. A Hardware Setup Connect Camera Link Cable 1. Connect one end of the Camera Link cable to the ES 1020, and the other end to the Frame Grabber board installed in the …

16, Redlake MASD MegaPlus ES 1020 MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 16 91000134-001 Rev. A Camera Mode Descriptions The Camera operates in one of four modes; free run, trigger programmed exposure, trigger manual exposure and trigger double exposure. The mo…

25, MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 25 91000134-001 Rev. A Timing Generator 02 00 TG Timing Read/Write 0x3b54 02 01 TG Control Read/Write 0x0000 02 02 TG Partial Scan Start Read/Write 300 02 03 TG Partial Scan Stop R…

8, MegaPlus ES 1020 User’s Manual Redlake MASD, Inc. Page 8 91000134-001 Rev. A 3. Camera Control Software User’s Guide The ES 1020 Camera Control Software is designed to run concurrently with image acquisition software. Both programs must be ins…