ACCO Brands NOBO X23M Operation & User’s Manual

11, ACCO Brands NOBO X23M 11 INST ALLATION POWERING ON THE PROJECTOR 1 Remove the lens cap. 2 Ensur e that the power cord and signal cable are securely connected. The Power LED will flash green. 3 Turn on the lamp by pressing “Power/Standby” button on the control panel. And the Power LED will turn green. The fir…

14, 14 INST ALLATION Y ou may turn the zoom ring to zoom in or out. To focus the image, rotate the focus ring until the image is clear. The projector will focus at distances from 1.2 to 10.0 meters. ADJUSTING THE PROJECTOR ZOOM / FOCUS ADJUSTING PROJECTED IMAGE SIZE Focus Ring Zoom Ri…

31, 31 Please note that damage resulting from incorrect installation will invalidate the war ranty. APPENDICES CEILING MOUNT INSTALLATION 1 To prevent damaging your projector, please use the ceiling mount package for installation. 2 If you wish to use a thir d party ceiling mount kit, pl…

9, 9 INTRODUCTION REMOTE CONTROL Page Up / Page Down Keystone Correction Menu Enter Four Directional Select Keys VGA Source Composite Video Source S-V ideo Sour ce Freeze Volume ( + / - ) Reset Re-Sync Hide T ransmit Indicator Light Power DVI-D Source …

28, The pr ojector will detect the lamp life itself. It will show you a warning message “Lamp is approaching the end of its useful life in full power operation. Replacement Suggested!” When you see this message, change the lamp as soon as possible. Make sure the projector has been…