Edge-Core Direk Tronik 24/48-Port Management Manual

463, Edge-Core Direk Tronik 24/48-Port GVRP and Bridge Extension Commands 52-3 52 switchport gvrp This command enables GVRP for a port. Use the no form to disable it. Syntax [no] switchport gvrp Default Setting Disabled Command Mode Interface Configuration (Ethernet, Port Channel) Example show gvrp configuration Thi…

110, Simple Network Management Protocol 11-10 11 CLI – Use the snmp-server user command to configure a new user name and assign it to a group. Configuring Remote SNMPv3 Users Each SNMPv3 user is defined by a unique name. Users must be configured with a specific security level and assigned to a…

268, Switch Clustering 30-2 30 Web – Click Cluster, Configuration. Figure 30-1 Cluster Configuration CLI – This example first enables clustering on the switch, sets the switch as the cluster Commander, and then configures the cluster IP pool. Cluster Member Configuration Adds Candidate sw…

222, VLAN Configuration 23-14 23 3. After packet classification through the switching process, the packet is written to memory with one tag (an outer tag) or with two tags (both an outer tag and inner tag). 4. The switch sends the packet to the proper egress port. 5. If the egress port is an u…

428, Link Aggregation Commands 46-10 46 Table 46-3 show lacp internal - display description Field Description Oper Key Current operational value of the key for the aggregation port. Admin Key Current administrative value of the key for the aggregation port. LACPDUs Internal Number of seconds …

472, VLAN Commands 52-12 52 switchport forbidden vlan This command configures forbidden VLANs. Use the no form to remove the list of forbidden VLANs. Syntax switchport forbidden vlan {add vlan-list | remove vlan-list} no switchport forbidden vlan • add vlan-list - List of VLAN identi…