Accton Technology EtherHub-16 Quick Start Manual

7, EtherHub-16 Quick Start Guide 7 EMI Warning FCC Class A Certification This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received,including …

5, EtherHub-16 Quick Start Guide 5 AUI Port This hub has two built-in AUI transceivers (i.e., AUI1 and AUI2) on the rear panel for connection using thick Ethernet cable (10BASE5) or fiber optic Ethernet cable (10BASE-F). To use either AUI port, set the DIP switches to the correct position…

6, EtherHub-16 Quick Start Guide 6 Symptom: Jabber indicator lights up. Causes: Frame received on this port exceeds length threshold for Jabber Lockup Protection. Solution: If jabber lockup has occurred, it will be automatically re-enabled when the problem is corrected or the port receives a vali…

3, EtherHub-16 Quick Start Guide 3 Providing Power to the Hub 1. Power on the hub by plugging the power cord into the power socket at the rear of the hub, and the other end into a power outlet. 2. Check the LED marked Power on the front panel to see if it is on. The unit automatically selects a set…

8, Accton Technology EtherHub-16 EtherHub-16 Quick Start Guide 8 You may find the following book prepared by the Federal Communication Commision helpful: The Interference Handbook This booklet is available from the U.S. Government Printing Office. Washington, D.C. 20402. Stock No. 004-000-00345-4. Safety Compliance Underwriters L…