RFNet APRT-2801 Operation & User’s Manual

7, Page 7 of 55 3 CONNECTIONS 4 LED LAN LED Blinking : Indicates connection to a Ethernet-enable computer WLAN LED Blinking : Indicates wireless LAN is ready Power LED A solid light indicates a proper connection to…

28, Page 28 of 55 Wireless > Advance Setting This page allows you to configure the advance wireless setting of the Router. Data Rate (Mbps): You can set the wireless data rate from the available list or choose Best to allow the Router to choose the most appropriate data r…

12, Page 12 of 55 To access the Configuration menu of the Router, connect the router as shown in the previous section. Open the web browser. Type the Router’s default IP address (192.168.1.20) into the browser’s Address field. Note: If you have changed the defaul…

8, RFNet APRT-2801 Page 8 of 55 5 BASIC IP NETWORKING Internet Protocol (IP) IP stands for Internet Protocol. In an IP network, every device has a unique IP Address (For example: 192.168.1.35) to identify itself. There are two ways of assigning an IP address to a PC or Router:…

31, Page 31 of 55 USB Settings > User Settings The USB Settings screen shows which login accounts are enabled. The following fields are displayed User to be added • Username. Type in your login username. • Password. Type in your login password. • Retype Passw…

35, Page 35 of 55 DHCP > DHCP Server This page is to configure the properties of the Router’s built-in DHCP Server. Take note that the built-in DHCP Server distributes IP Addresses to both the LAN ports and the WLAN clients. Enable DHCP Server: Tick to enable the built-in DHCP …