Risco GT 600 Manual, User Instructions

46, Page 45 GT 600 601 User Manual Display Blanking Depending on the level of your system and the legislation that it is required to comply with your installation company may have initialised Display Blanking. When this is used the Status of the system will only be indicated on the displa…

41, Page 40 GT 600 601 User Manual 10) This determines if using this user code to set the system will trigger the Vo-Comm. (For more details on Vo-Comm please refer to the Vo-Comm section). Press NO until the setting you require is displayed (YES or NO). Then press Yes. Note: The Vo-Comm …

35, Page 34 GT 600 601 User Manual The readers will be allocated to a specific keypad. The G-Tag information is stored in the keypad therefore a single keypad having two readers would only require the G-Tag to be programmed into one of its readers For multiple keypads with readers the sequence for…

3, Risco GT 600 Page 2 GT 600 601 User Manual User Information Customer Name:- Customer Address:- System Information No of Keypads Keypad 1 Location Type Keypad 2 Location Type Keypad 4 Location Type Keypad 5 Location Type Keypad 6 Location Type Keypad 7 Location Type Keyswitch 1 Location, Area 1, User Code N…

6, Control Code Levels (affecting an output) Control Allows an output that has been pre-programmed by the installation company to be operated. May also have an attribute of Can or Can’t Unset. Control level codes can never Set a system. Page 5 GT 600 601 User Manual 600 601 PR600601…