Rogue Audio Stereo 100 Owner's Manual

5, 4 Connecting the Stereo 100 to the preamplifier: The input connections from the preamplifier are made via either RCA or XLR connections on the rear of the amplifier. See figure 2. Be sure to use high quality interconnect cables – they do make a difference. Figur…

3, 2 INTRODUCTION Congratulations on your purchase decision! We at Rogue Audio truly believe that our amplifiers provide the “smartest” value in high-end audio. If you have never owned a vacuum tube amplifier you will be thrilled by the silky-smooth sound and incredible deta…

9, 8 FUSE VALUES Main fuse located on rear panel (1) – 5 Amp slow blow Tube Fuses (4) – 1/4 Amp slow blow SPECIFICATIONS output power 100 WPC frequency response 5Hz – 50 kHz  1dB THD < 0.1% typ, < 1% at rated power input s…

7, 6 SETTING THE TUBE BIAS Tools required: bias tool (provided with amplifier) The output tubes (the big ones) need to be “biased’ with a grid voltage that controls the flow of electrical current through the tube. Tube biasing on the Stereo 100 …

2, 1 TABLE OF CONTENTS 1) Introduction 2 2) Unpacking the Stereo 100 amplifier 2 3) Installing the Stereo 100 into your system 3 4) Operation of the amplifier …

6, Rogue Audio Stereo 100 5 OPERATION OF THE AMPLIFIER After all proper connections have been made, you are now ready to turn the Stereo 100 amplifier on. The power on/off switch is on the front of the amp. Some preamplifiers and sources can generate danger…