Sabre Switch TRIGGERSMART Instruction Manual

14, 5. Switch on the power to the MCT-1 unit with the POWER ON/OFF switch on the rear of the MCT-1 unit. 6. Place the INFRARED RECEIVER/LIGHT INTENSITY SENSOR UNIT facing towards the expected light source. Adjust the SENSITIVITY, increasing the sensivity unl the…

6, BRIEF OVERVIEW THE SENSOR UNITS THE SOUND SENSOR. A sensive microphone is used to detect any sharp sound, such as an impact or the sound of breaking glass. When detected the unit operates the camera shuer and, if necessary, the camera’s internal ash and/or addional slave as…

13, 15. Drop an object onto the table in the camera’s view area and the sound of the impact will trigger the camera. The microphone is sensive enough to capture the sound of quite small objects but extraneous noise must be kept to a minimum. 16. Trial…

8, Sabre Switch TRIGGERSMART armed, the LED will glow GREEN and the system is then ready to receive the next input from the sensors which will trigger the camera. If the AUTO ARM switch is set to AUTO the LED will glow GREEN to indicate that the system is armed and the camera will be triggered by the next event and each …

7, THE CONTROL UNIT EXPLAINED The control unit is housed in a tough but compact case that is splash-proof and has a wipe clean surface that incorporates LED indicators and touch switches. The control panel houses three rotary control knobs and six touch sensive switches. The operaon and d…

19, TRIGGER INPUT TO CAMERA IMPORTANT SAFETY INSTRUCTIONS Every consideraon has been taken to ensure correct operaon of this prod- uct with most cameras. However, no connecon to a camera or other equip- ment should be made unless the operator is certain of the compability of the…