Sea-doo SEASCOOTER PRO Operation & User’s Manual

10, Charging the battery For battery charging follow these instructions. 1. Always ensure that the Master Switch is Off - see figure 3. 2. Always ensure that the SEA-DOO ® SEASCOOTER™ is out of the water, dry and placed in a dry area. 3. Give a half turn to the Latches and remove t…

2, Contents Introduction Introduction 1 Parts diagram 2 Warnings 4 Getting started 6 Battery use 11 Charging the battery 15 Care & maintenance 21 Trouble shooting 23 Technical specifications 28 Thank you for having chosen the SEA-DOO ® SEASCOOTER ™ PRO / GTI / VS SUPERCHA…

17, 30 *Normal Use The definition of normal use is based on the average general time of use the user activates the seascooter in the water. ∆ Continuous Use The definition of continuous use is based on a fully charged battery whereby the seascooter is used continuously in the water with…

6, Sea-doo SEASCOOTER PRO 5. When ready to set off, turn the Master Switch to the On position shown in figure 3. 6. Pull and hold both Triggers to start the Propeller. (There is a short delay before the Propeller begins to rotate). 7. To stop the Propeller, simply release the Triggers. 8. Always turn the Mast…

12, To replace a flat battery with a fully charged battery. 1. Follow the steps 1 to 7 on page 16, to open the SEASCOOTER ™ . 2. Unplug the battery at the socket by pressing the locking feature shown in figure 8. 3. Remove the flat battery. 4. Install and connect the charged battery in …

11, 15. Unplug the battery cable from the Charger cable. 16. When ready for use, install the battery and reconnect to the housing cable. 20. Screw in the Vent Plug to seal the vent. 21. Replace the Buoyancy Control Chamber. 22. Replace the Outer Nose Cone making sure the key is aligned correctly…