Sentry360 IS-IP200-DN Operation & User’s Manual

12, 5. Configure Video Streams Users can setup Video Resolution on the Video Format page of the user-friendly browser-based configuration interface. Video Format can be found under this path: Streaming > Video Format. Click on <Save> to confirm the setting. …

10, The default login ID and password for the Administrator are: Login ID Password Admin 1234 NOTE: ID and password are case sensitive. Installing DC Viewer Software Online For the initial access to the IS-IP200-DN, a client program, DC Viewer, will be automatically installed to…

6, Sentry360 IS-IP200-DN 2. Camera Cabling Please follow the instructions below to complete the IS-IP200-DN installation. 2.1 Connect Power Please refer to SECTION: CONNECTORS. Alternatively, connect the Ethernet cable to the camera’s PoE port and plug the other end of the cable into a PoE switch. NOTE: If u…

2, Table of Contents 1. Overview ............................................................................................................................ 3 1.1 Features ................................................................................................................…

9, Step 5. Confirm your network settings and click Configure. Step 6. To manually configure your cameras, click Edit Camera Values at the bottom right, enter your IP Address, Subnet Mask, Gateway, and DHCP settings. Click Apply to save these values. Step 7. Your cameras are now config…