Sime Ecomfort Plus 30 HE Manual, Installation And Servicing Instructions

23, 23 4.11 CHIMNEY SWEEP FUNCTION (fig. 23) To carry out the verification of combustion in the boiler turn the selector and stop on the position ( ) until the green/orange led starts to flash intermittently. From that moment the boiler will start func- tioning in heating mode at the …

21, 21 SIME SUPPORT THE BENCHMARK INITIATIVE All relevant sections of the Benchmark Checklist must be filled in at the time of installation. Commissioning of the boiler is not complete until this is done. The boiler service record must be completed at each service. 4.1 FILLING THE WATER SYSTEM – Open…

12, Sime Ecomfort Plus 30 HE 12 exceed 5.0 meter (25 HE) - 3.0 meter (30 HE). When the vertical extension code 8086950 is used, the terminal part of the pipe must always come out horizontally. 2.6 COAXIAL DUCT ø 80/125 (only for “30 HE” model) The air inlet-smoke outlet assembly ø 80/125 is supplied in a k…

36, 36 Fonderie Sime S.p.A. - Via Garbo, 27 - 37045 Legnago (Verona) - Tel. +39-0442-631111 - Fax +39-0442-631292 - www.sime.it ETONLEDOMNOITPIRCSEDEDOCNOITISOP EPYT .DOC EGAPETAD • Recommended stock parts - Componenti da tenere a scorta ETONLEDOMNOITPIRCSEDEDOCNOITISOP 80 6009585 Cont…

32, 32 Fonderie Sime S.p.A. - Via Garbo, 27 - 37045 Legnago (Verona) - Tel. +39-0442-631111 - Fax +39-0442-631292 - www.sime.it ETONLEDOMNOITPIRCSEDEDOCNOITISOP EPYT .DOC EGAPETAD • Recommended stock parts - Componenti da tenere a scorta ETONLEDOMNOITPIRCSEDEDOCNOITISOP 1 6138570 Side frame part …

29, 29 Note: Use silicone grease to ease the fit- ting of any push fit connections. 6.1 Expansion Vessel – Isolate power supply – Remove boiler cover – Isolate flow and return valves – Drain boiler using fitted drain vent – Disconnect expansion pipe – Remove expansion vessel…