SmartWitness SVC1080-LCA Operation & User’s Manual

16, www.smartwitness.com 16 The SD card can be removed in the SVC1080-LCA using 2 different methods; 1. Turn the ignition off and remove the SD card 2. Take out the SD card when the unit is on using the safe SD card removal mode. 1. Turn the ignition off in the vehicle and take o…

13, www.smartwitness.com 13 Parking Mode The parking mode function allows you to record data when your vehicle is parked. If the G-sensor value changes are less than 50mg for 5 minutes, the recording frame rate will drop to 1fps. When the vehicle stars to move again, the parking mode wil…

33, SmartWitness SVC1080-LCA www.smartwitness.com 33 CLOUD BACKUP SmartWitness offers a Cloud backup service allowing you to store backed up footage. To do this, simply create an AVI le back up as shown on the previous page and press the ‘Cloud Upload’ button (shown below). When you have clicked the ‘Upload…

15, www.smartwitness.com 15 1. Connect the red Fuse Cable (+) to the Fuse box in the vehicle. This should be connected to a battery circuit. We recommend that the SVC1080-LCA is wired so that it is only powered when your ignition is turned on. If you wish to power permanently, then please use our …

37, www.smartwitness.com 37 Top Graph The top graph shows the speed (red) and RPM (grey) and below are three indicator bars that show driving patterns. The rst bar shows driving (blue) and idling (grey) and the second bar shows the speed. White means that the vehicle was within both the…

7, www.smartwitness.com 7 2. INTRODUCTION FRONT Bracket Stick adhesive tape here Camera Lens Tamper Resistant Locking Case RIGHT LEFT Key Lock Protects SD Card Slot DC Power Input Connected with permanent wiring REAR SD Card Format Button Record Button Record LED Blue LED Overwrite LED Red LED …