General Standards Corporation PCI-DIO24PMC-DIO24PCI-DIO24-GD1 Operation & User’s Manual

13, DIO24, User Manual 2.3.1.1. PLX Default Configuration: J2:1-2 This jumper connects the PCI interface chip (the PLX PCI9080) to the On-board Configuration EEPROM (Serial EEPROM U42). When the jumper is installed, the PCI interface chip will initialize some of its registers from t…

18, DIO24, User Manual 4.3.4. I/O Control Register (IOCR, 0x60, 32, RW) This register is used to configure the I/O ports and bits as either inputs or outputs. Setting a bit to one programs the port/bit as an output. Setting a bit to zero programs the port/bit as an input. Bit 31 30 29 28 27 26 …

28, DIO24, User Manual 5.4. DMA Registers The DMA Registers are not used on the DIO24. 5.5. Messaging Queue Registers The Messaging Queue Registers are not used on the DIO24. 28 General Standards Corporation, Phone: (256) 880-8787 …

20, General Standards Corporation PCI-DIO24PMC-DIO24PCI-DIO24-GD1 DIO24, User Manual 5. PLX PCI9080 Registers These registers are provided by the PCI interface chip, which is the PLX PCI9080. Since many of the PCI9080 features are not utilized in on the DIO24, it is beyond the scope of this document to duplicate the PCI9080 User’s Manual. Only those register…

3, DIO24, User Manual Preface Copyright ©2002, General Standards Corporation Additional copies of this manual or other literature may be obtained from: General Standards Corporation 8302A Whitesburg Dr. Huntsville, Alabama 35802 Phone: (256) 880-8787 FAX: (256) 880-8788 URL: w…

29, DIO24, User Manual Document History Revision Description December 3, 2001 Initial Release December 11, 2001 Added Plug and Play information. February 13, 2002 Added system resource and loop back cable information. October 23, 2002 Added information about the new subsystem ID of …