Ikelite 6973.03 Instruction Manual

16, Bulkhead Cap Sync Cord O-ring Housing or Strobe Bulkhead Ikelite TTL Sync Cord Sync Cord Pin Knurled Nut 3. Line up the Sync Cord Pins with the corresponding Bulkhead Receptacles. Gently insert Sync Cord ends into each Bulkhead. Either Cord End may be attached to a component. DO NOT force…

25, 25 - The number one rule in underwater photography is to eliminate as much water between the camera and subject as possible. Get as close as you can to the subject, then use the zoom. If you are using flash for still photos, subjects beyond 6 feet (1.8 m) will not have much color regardless of st…

3, 3 This product has been water pressure tested at the factory and is depth rated to 200 ft (60 m). Thoroughly inspect and immerse the empty housing completely in water before installing a camera. If any fogging occurs or droplets of water enter the housing, do not install a camera. Clean the main …

1, Ikelite 6973.03 Thank you for your purchase of Ikelite equipment. Please read this instruction manual completely before attempting to operate or dive with this product. Please refer to the back page of this manual to register your Ikelite product. Underwater Housing for Canon EOS M3 Product Number 6973.03 …

5, 5 Parts of the Housing - Front View Shutter Button Lens Port Base External Tray Mounts Lid Snap Front Dial External Strobe Connector & Cap Lens Release Button Exp. Comp. Dial M-Fn Button Fiber Optic Ports Flash Pop-up Switch …

28, 28 Water enters the housing - Remove, clean and properly lubricate the main o-ring. - Look for hair, dirt, or foreign debris crossing the o-ring seal. - Reassemble the housing without a camera installed and pressure test or take diving. - Return housing to Ike…