Adaptec RAID 5085 Installation And User Manual

22, Chapter 3: About Your RAID Controller ● 22 About the Adaptec RAID 5445 The Adaptec RAID 5445 is a SAS RAID controller with these features: Form Factor Low-profile MD2 Bus compatibility PCIe 1.1 PCIe bus width x8 Data transfer rate 3 Gb/s per port Phys (Unified Serial Ports) 8 Standard cache …

78, Adaptec RAID 5085 Chapter 10: Solving Problems ● 78 If there are more disk drive failures than hot spares, see Failed Disk Drive Not Protected by a Hot Spare. If copyback is enabled, data is moved back to its original location once the controller detects that the failed drive has been replaced. Disk Dri…

40, Chapter 4: Getting Started ● 40 Selecting Disk Drives and Cables Disk Drives Your SAS controller supports SAS disk drives, SATA disk drives, SATA and SAS Solid State Drives (SSD), and Adaptec MaxIQ Solid State Drives. When selecting disk drives for your RAID array, ensure that all the disk d…

116, Appendix E: Controller LED and I2C Connector Quick Reference ● 116 J12: ● Adaptec RAID 5085 Status LED Board Connector: Molex 10-89-7162 or equivalent ● Status LED Mating Cable Connector: Molex 22-55-2161 or equivalent J14: J12 Pin Number Signal Description 2 ~2kHz Square Wav…

99, Appendix C: Using the Adaptec RAID Configuration Utility ● 99 Modifying Cache Settings You can modify the read and write cache settings for an array. You can also modify the MaxIQ cache settings. The MaxIQ cache uses the MaxIQ-compatible Solid State Drives in your system as a rea…

67, Chapter 8: Installing the Driver on an Existing Operating System ● 67 Before You Begin Before you begin, install and connect your Adaptec RAID controller and internal disk drives (see page 43). You must also create a driver disk before you begin installing the controller driver. Not…