Adaptec RAID 5085 Operation & User’s Manual

19, Chapter 2: Using the Command Line Utility ● 19 arcconf setalarm Sets the state of the controller audible alarm, if present. Syntax ARCCONF SETALARM <Controller#> <on|off|silence|test> Parameters Controller# is the controller number On enables the alarm Off disables the alarm Silence q…

27, Adaptec RAID 5085 Chapter 2: Using the Command Line Utility ● 27 hrconf romupdate Note: This command is only available on systems running Windows or Linux. Updates the controller or enclosure firmware. The ROM image file must be in the same directory prior to invoking hrconf. Syntax HRCONF ROMUPDATE <Contro…

28, Chapter 2: Using the Command Line Utility ● 28 hrconf setstate Redefines the state of a physical device from its current state to the designated state, or redefines a logical device state to force the logical drive online. Syntax HRCONF SETSTATE <Controller#> LOGICAL DRIVE <LogicalDr…

9, Chapter 1: Getting Started with the Command Line Utility ● 9 3 Extract the Linux Adaptec Storage Manager RPM package and install it: rpm --install ./StorMan*.rpm Note: Ignore the note saying "Application can be started by typing /usr/StorMan/ StorMan.sh". VMWare does not…

15, Chapter 2: Using the Command Line Utility ● 15 arcconf getlogs Obtains controller log information. Provides access to the status and event logs of a controller. You can retrieve three types of logs: ● DEVICE—A log of any device errors the controller has encountered. ● DEAD—A lo…

5, Contents ● 5 arcconf snapshot ......................................................................................... 21 arcconf task ................................................................................................. 22 HRCONF Commands ......................................…