Martin Professional Wizard Extreme Operation & User’s Manual

33, Basic service 33 • The Wizard Extreme update file, available for download from the User Support Area of the Martin web site (http://www.martin.com). • The Martin Software Uploader program, version 4.0 or later, available for download from the User Support Area of the Martin we…

10, 10 Wizard Extreme user manual US model 1. Disconnect the fixture from AC power. 2. If the lamp is hot, allow it to cool for 5 minutes and wear safety goggles to protect your eyes. 3. Remove the six cover-access screws (see diagram inside the cover of this manual) and lift off the fixture cov…

30, Martin Professional Wizard Extreme 30 Wizard Extreme user manual 3. If replacing a lamp, grasp the old lamp by the reflector and pull it out of the holder. Then pull the socket off the lamp. Do not pull the wires. 4. Push the socket fully onto the pins of the new lamp. 5. Clean the glass bulb with the cloth supplied w…

8, 8 Wizard Extreme user manual AC POWER The Wizard Extreme’s operating voltage is printed on the serial number label that can be found on the back of the Wizard Extreme. Verify that the operating voltage closely matches the AC supply voltage before applying power. Contact your Martin dealer if th…

13, Installation 13 where the load is greatest. This will depend on the angle that the Wizard Extreme is set at. 2. Place the fixture on the floor. Adjust the mounting bracket and tighten both swivel locks. 3. Verify that the fixture is stable, that it is at least 0.1 meters (4 in.) fro…