Inflight Fitness VANGUARD Assembly Manual

9, 14 15 VANGUARD ASSEMBLY INSTRUCTIONS MPS/MLA STATION CABLE ASSEMBLY (CONTINUED) F1. Thread the P13-0452 cable into the threaded boss in the Top Weight. Remember to slide the loop of the weight pin lanyard onto the cable/topweight if you have not done so already. Note: There is a max…

12, 20 21 VANGUARD ASSEMBLY INSTRUCTIONS SHROUD ASSEMBLY NOTE: If you are not installing shrouds proceed to Step K2 on pages 22 and 23. Then proceed to pages 26 and 27 for placard installation. Then proceed to pages 28 and 29 for cable adjustment. NOTE: Some of the screws and washers are pre-insta…

5, 6 7 VANGUARD ASSEMBLY INSTRUCTIONS MAIN STRUCTURE ASSEMBLY B1. Assemble the Top Frame to the Main Upright using 2 – 3/8” x 3” bolts, 4 – 3/8” flat washers and 2 – 3/8” nuts. Do not fully tighten the bolts at this time. B2. Assemble the Vertical Tubes to the Lower Frame and To…

2, Inflight Fitness VANGUARD 1 VANGUARD ASSEMBLY INSTRUCTIONS IMPORTANT NOTICES IF YOU ARE ASSEMBLING THIS VANGUARD FITNESS MACHINE WITH EITHER THE LEG PRESS OR CABLE COLUMN OPTION STOP NOW AND USE THE ASSEMBLY MANUAL INCLUDED WITH THE OPTION. Read all warning labels, instruction placards and this manual before atte…

8, 12 13 VANGUARD ASSEMBLY INSTRUCTIONS MPS/MLA STATION CABLE ASSEMBLY E1. The Press Arm and Pillow Block Bearings attach to the Bearing Brackets using 4 – 3/8” x 1 ¼” bolts, 8 – 3/8” washers, and 4 – 3/8” nuts. Note: The pillow Block Bearings install with the setscrews to the outside…

6, 8 9 VANGUARD ASSEMBLY INSTRUCTIONS WEIGHT STACK INSTALLATION C1. Insert 2 - Guide Rods into the two large holes in the Mid Frame near the center of the machine. Allow Guide Rods to lean together out the side of the machine. Place one weight stack cushion on each Guide Rod a…