Gtec ZP120N Operation & User’s Manual

12, 20 External Battery Cabinet Positive Pole(+),Neutral pole,Negative pole(-), Min.conductor cross section[mm 2 ] Max.conductor cross section[mm 2 ] 10 13 21 25 Line input Backfeed protection device A 4-pole disconnection device with 100A/250VAC, less than 15s break…

24, 44 10) Do not switch on the output breaker of each UPS, switch on the input breaker of the each UPS, the UPS should work in bypass with output, observe their display to check if there are any warning or fault information, measure the output voltage of each UPS separately to check if t…

11, 18 8) To connect the load with the UPS, please turn off all the loads first, then perform the connection and finally turn on the loads one by one. 9) No matter the UPS is connected to the utility power or not, the output of the UPS may have electricity. The parts inside the…

23, 42 4) Strictly follow the chapter of 4, the wiring requirement of single UPS to perform the wiring of each UPS. 5) Connect the output wires of each UPS to an output breaker panel. 6) Disconnect the Jumper on JP1 and JP2 of the terminal block first, and connect each output breaker…

21, Gtec ZP120N 38 function loss, even directly damage the load, battery or UPS. The most of settings could only be done while UPS is in Bypass mode. Fig. 5-19 Setting menu tree *:Password is USER when enabled 39 Example: set rated output voltage value …

9, 14 Remove the packaging following the sequence illustrated in Fig. 4-1 to Fig. 4-4. （only for tower 3/1 10k-20k） Tools kit Lifter Phillips screwdriver Scissors Wrench Fig. 4-1 Unpacking-step1 Fig. 4-2 Unpacking-step2 15 The shipping materials a…