J. A. Roby GRIZZLY FURNACE Instruction Manual

18, September 13, 2016 18 6- Fix the electrical box, the thermostat junction box, the F120 thermodisc with the 1/2 inch long screws. Verify that no electrical wire touches the hot surface of furnace. 7- Install the chain linking th…

23, September 13, 2016 23 COMBUSTION AIR SUPPLY Combustion air supply can be done by either of following methods: Indirect method: In the case of an appliance not certified for a direct connection with a source of new air supply, the new air is brought in a duct at a maximum of 3…

20, September 13, 2016 20 DIRECT VENT DOOR The appliance is equipped with a direct vent door which gives access to the heat exchanger. When the door is open, the heat accumulated in the heat exchanger directly comes out from there. Even if there is a power outage, the furnace keeps heat…

2, J. A. Roby GRIZZLY FURNACE September 13, 2016 2 TABLE OF CONTENTS SPECIFICATIONS – GRIZZLY FURNACE .......................................................... 3 DIMENSIONS ....................................................................................................... 3 CLEARANCES ..................…

14, September 13, 2016 14 7. Insert the 2 other pipes in the stove passing through the hook of the pipes. 8. Insert the 4 bricks on the pipes (4 x bricks E) and the wool, then put the steel plate over the wool. ***IMPORTANT*** Make sure that the wool don't obstruct t…

15, September 13, 2016 15 FAN AND THERMODISC The 115 volt fan must be screwed at the place provided for this purpose at the back of the appliance. The F120 thermodisc must be fixed beside the junction box in the holes made for the installation. When the appliance is in function, the heat reach…