JAI SW-2000M-CL-65 Operation & User’s Manual

14, SW-2000M-CL-65 14 5.10 Camera Link interface One Camera Link connector is available to connect standard Base Configuration interface devices (frame grabber boards, etc.) to receive image data, to control the scan rate and exposure of the camera, as well as to communicate via the Ca…

33, JAI SW-2000M-CL-65 SW-2000M-CL-65 33 7.3.4 ROI – region of interest This command can be used to select only specific sections of each line to be sent out. Up to four regions can be defined. The selected parts of the line will be combined together to make one, shorter line. There a…

42, SW-2000M-CL-65 42 9.2 JAI Sweep Ethernet Tool The Sweep Ethernet Tool is a telnet terminal program with possibility to run scripts and to display single line graphs (average of 32 lines). Fig.8. Front page after initialization and the help command. …

15, SW-2000M-CL-65 15 5.12 Firmware updates It is possible to update or change the camera firmware without opening the housing. New code is loaded in via the Ethernet port and with help of web browser user interface. There are two kinds of firmware updates: MCU and…

39, SW-2000M-CL-65 39 B – Commands affecting exposure Command Function Command Format Parameter Remarks 1 Sensor operating mode SENSOR DYNAMIC RESPONSIVE Larger capacity, lower noise. Smaller capacity, higher responsivity. 2 Line interval LINE P…

26, SW-2000M-CL-65 26 7.2 Group B: Commands affecting exposure 7.2.1 SENSOR – selects the sensor mode The sensor has two possibilities of collecting the light generated charge. The default setting uses the larger well size for a wider dynamic range and a better …